Idiomas disponibles
Idiomas disponibles
5. Select the desired OPTIONS. Not all Options are available
with all cycles. See "Options."
6. Select the desired MODIFIERS. Not all Modifiers are available
with all Cycles and Options. See "Modifiers."
7.
If desired, select the CYCLE SIGNAL. The signal is helpful
when you are washing items that should be removed from the
washer as soon as it stops. Press CYCLE SIGNAL once to
turn it on. The indicator light will illuminate. Press again to
turn it off.
8. To begin the wash cycle immediately
Select and hold START (for approximately
1 second).
•
If you do not select START within 5 minutes of choosing a
cycle, the washer automatically shuts off.
•
When the wash cycle is complete, the CLOTHES CLEAN
status light illuminates, the door unlocks, and the wash
load can be removed from the washer. The washer
powers down automatically
5 minutes after the cycle is
complete and the CLOTHES CLEAN light goes off. To
power down the washer manually after the wash cycle is
complete, select STOP once.
9. To begin the wash cycle later
Select DELAY START until the desired delay time (in hours)
shows. Select START.
•
When delaying a cycle, use only powdered detergents in
the main wash compartment
since liquid detergents may
seep out of the compartment
during Delay, before the
wash cycle begins.
Your new washer has a dispenser drawer with three separate
compartments
for your laundry additives--one
is for detergent,
one is for liquid chlorine bleach, and one is for liquid fabric
softener. Laundry additives are diluted and dispensed
automatically
at the proper time during the wash cycle, making it
unnecessary for you to return to the washer during the cycle to
add them.
It is normal for small amounts of water to remain in the
dispensers when the wash cycle is complete.
Do not put laundry additives directly into the wash tub. Always
use the proper dispensers when adding laundry additives.
Choosing the Right Detergent
Use only High Efficiency detergents. The package for this type of
detergent will be marked "HE" or "High Efficiency." This wash
system, along with less water, will create too much sudsing with a
regular non-HE detergent. Using regular detergent will likely result in
washer errors, longer cycle times and reduced rinsing performance.
It may also result in component failures and noticeable mold or
mildew. HE detergents are made to produce the right amount of
suds for the best performance. Follow the manufacturer's
instructions to determine the amount of detergent to use.
Use only HE High Efficiency detergenL
To fill dispenser
compartments
1. Pull out the dispenser drawer.
2. Add the desired laundry product to the proper compartment.
3=
Push in the dispenser drawer slowly and completely (to avoid
a spill).
A
Dispenser
A. Dispenser release lever
B. Main Wash detergent compartment
C. Liquid chlorine bleach compartment
D. Fabric softener compartment
Main Wash detergent
compartment
(Letter B in Dispenser Illustration)
Add liquid or powdered HE detergent to this compartment
for
your main wash cycle.
•
Powdered color-safe bleach may be added to the Main Wash
compartment
along with the powdered detergent.
•
Liquid detergent: Measure the amount of liquid detergent with
the measurement device which comes with the detergent.
Add no more than the manufacturer's
recommended
amount.
The liquid detergent flows immediately into the washer.
Powdered detergent: Measure the amount of powdered
detergent with the measurement
device which comes with
the detergent. Add no more than the manufacturers
recommended
amount.
•
Do not fill beyond the "Max" level
NOTE: Overfilling could cause an over sudsing condition.
Chlorine bleach compartment
(Letter C in Dispenser Illustration)
Add NO MORE THAN ¾ cup (160 mL) liquid chlorine bleach to
this compartment.
The bleach will be automatically
diluted and
dispensed at the best time during the first rinse after the wash
cycle. This compartment
cannot dilute powdered bleach.
•
Use only liquid chlorine bleach in this dispenser. Do not use
this dispenser to add powdered chlorine or any form of color-
safe bleach to your load.
•
Always measure liquid chlorine bleach. Use a measuring cup
with a pour spout; do not guess. Follow the manufacturer's
directions for safe use.
•
Do not fill beyond the "MAX" level.
NOTE: Overfilling could cause garment damage.
Fabric softener
compartment
(Letter D in Dispenser Illustration)
Add 1/4cup (60 mL) liquid fabric softener to this compartment.
Fabric softener will be automatically
dispensed
in the final rinse
or in the 2ND RINSE, if selected.
•
Do not fill beyond the "MAX" level.
14
