Roadstar CLR-2285/WD Manual De Instrucciones página 4

power cord to the AC household main outlet. Ensure that the voltage
is as indicated on the rating plate on the rear of the unit.
Battery Back-up Power Failure Protection
This radio has a battery back up circuit that will keep the correct time
and alarm settings in the event of a temporary power interruption.
Install a 3V battery (type CR-2032), not included, into the battery
compartment (11) located on the bottom of the unit.
Note: We recommend an alkaline battery for longer usable life.
Change the battery every 9 to 12 months for best result and avoid
possible battery leakage.
If power is temporarily interrupted the display will blink and the radio
will not play. However, the battery back-up circuit will continue to
maintain the clock and alarm settings. When power is restored the clock
will display the correct time and alarm settings, and no adjustment is
necessary.
Note: If power is interrupted and there is no battery in the compartment
or the battery is exhausted. The time and alarm settings will be
lost. When power is restored the clock will begin to flash
indicating that the time and alarm settings must be corrected.
DISPLAY
1. Normally the LCD DISPLAY indicates the DATE, which shows
the MONTH, YEAR, TIME and DAY.
2. Press YMD (9) button to show sequentially the above
informations.
English 3 4
SETTING THE LCD DISPLAY
1.
2.
3.
4.
6.
7. Press the MEM/M+ (3) button to conclude the setting.
SETTING THE ALARM (BUZZER OR RADIO)
1.
2.
English
In the normal Display mode, to set the TIME, keep pressed
MEM/M+ (3) Button until the YEAR digits will flash. Press UP/
DOWN (4-9) to adjust the YEAR digits.
To set the MONTH, press MEM/M+ (3) once more and the
MONTH digits will flash. Press UP/DOWN (4-9) to adjust the
MONTH digits.
To set the DAY mode, press MEM/M+ (3) once more and the
MEM/M+ (3) digits will flash. Press UP/DOWN (4-9) to adjust the
DAY digits.
To set the 12/24 mode, press MEM/M+ (3) once more and the
Year digits will flash. Press UP/DOWN (4-9) to adjust the 12/24
5. To set the HOUR, press MEM/M+ (3) again and the HOUR
digits will flash. Press UP/DOWN (4-9) adjust the HOUR digit.
To set the MINUTE, press MEM/M+ (3) again one more time
and the MINUTE digit will flash. Press UP/DOWN (4-9) to adjust
the MINUTE digit.
In the normal Display mode, press ALARM 1 (7) or ALARM 2 (8)
button once and the display will show the ALARM TIME. The
"AL" icon indicates that the display is showing the ALARM
TIME.
To set the ALARM TIME, press ALARM 1 (7) or ALARM 2 (8)