Snooze Function; Sleep Function; Care And Maintenance - Roadstar CLR-2466N Manual De Instrucciones

TUN- (3) or TUNE UP (4) button sequentially until the desired frequency
is displayed, press the Tune/Preset/Mem button (9) two seconds until
"P" flash, then press TUN/TIME+ (3) or - (4) button to store in the
memory.
5. To listen the desired Radio stations, short press Tune/Preset/Mem button
(9) button to select the stored station.
6. To turn off the radio, press the Power ON/OFF button (2).
Note: For FM reception there is a built-in FM antenna wire at the rear of
the unit. Move the wire around to obtain the best reception.

SNOOZE FUNCTION

When the alarm sounds, pressing the SNOOZE/SLEEP Button (1) will
temporary stop about 8 minutes then the alarm sounds again.

SLEEP FUNCTION

1. This function enables you to go to sleep listening to the Radio.
2. Press the Power ON/OFF button (2) to switch ON the Radio.
3. Press the SNOOZE/SLEEP Button (1) sequentially. The clock display
will show 10/20/30/45/60/90/120 minutes. The Radio turns on and will
turn off automatically after the selected sleep timer.
4. To turn off the Radio at any time during the Sleep period, press the
Power ON/OFF button (2) .

CARE AND MAINTENANCE

To prevent fire or shock hazard, do not allow this clock radio to be exposed
English 5 6 English
to rain or moisture.
This clock radio should not be exposed to direct sunlight, very high or low
temperature, moisture, vibration, or placed in a dusty environment.
Do not use abrasives, benzine, thinners, or other solvents to clean the
surfaces of the clock radio. To clean it, wipe with a mild non-abrasive
defergent solution on a clean soft cloth.
Never attempt to insert wires, pins, or other objects into the venlilation holes
or openings on the clock radio.
Note: When setting the Clock or Alarm times remember that this clock radio
has a 24 Hour clock mode.
AC POWER
For your own safety read following instructions carefully before attempting
to connect this clock radio to the mains.
This unit is designed to operate on a 230V~50Hz supply only. Connecting
it to other power sources may damage it.
Ensure that supply corresponds to the information on the rating label on the
bottom of the unit.
SPECIFICATIONS
FM Band: 87.5 to 108 MHz
Power Supply: 230VAC, 50 Hz
Power Consumption: 3W
Design and specifications are subject to change without notice.