Idiomas disponibles
Idiomas disponibles
Starting the charging process
Connect the appropriate adapter to the charging
system.
Connect the charging system to the mains socket
or the charging device.
The charging system will carry out an LED test that
lasts for approximately two seconds.
When charging at a mains socket:
If the "grounding" LED flashes red, no protective
earth conductor has been detected at the socket
used.
Depending on the country and the socket used, it
may be necessary to switch off protective earth
conductor detection.
Please refer to the section "Switching off
protective earth conductor detection" (
If you want to set the maximum charging current,
also refer to the section "Setting the maximum
charging current" (
Connect the charging system to the vehicle.
Charging will start automatically.
A flashing green light on AMPERE scale (8)
indicates an active charging process. The
"charging" LED will also light up green.
page 20)
page 19).
power source
32
24
car connection
20
temperature
16
charging
10
communication
8
6 A
grounding
Ending the charging process
End the charging process at the vehicle (see
vehicle Owner's Manual).
The vehicle socket is unlocked. If you are charging
at a type-2 charging station, the plug is also
unlocked.
Disconnect the charging system from the vehicle.
Disconnect the charging system from the mains
supply.
Stow the charging system securely.
Setting the maximum charging current
The basic setting and adjustable maximum value
depend on the adapter used and may therefore vary.
Adapter
Household socket
CEE 16 A 1-phase
CEE 16 A 3-phase
CEE 32 A 1-phase
CEE 32 A 3-phase
It is not possible to increase the maximum charging
current beyond the maximum value mentioned here for
safety reasons.
- 19 -
M+P-03F-9992
Basic
Maximum
setting
value
6 A
8 A
10 A
16 A
10 A
16 A
10 A
32 A
10 A
32 A
