Frequency Error; Voltage Error; Low Current; Excess Current - HURNER HST 300 HP 2.0 Manual De Instrucciones

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany

11.2.4 Frequency Error

The frequency of the input voltage is out of tolerance
(42 Hz - 69 Hz).

11.2.5 Voltage Error

Check generator voltage and current. The output voltage
does not correspond to the value previously read; the weld-
ing unit has to be sent to the manufacturer for check-up.

11.2.6 Low Current

The message is displayed if the there is a momentary cur-
rent failure or if the current decreases by more than 15%
per second for 3 seconds.

11.2.7 Excess Current

The output current value is in excess; possible causes: short-
circuit in the heater coil or the welding cable. During the
start stage the upper abort threshold equals 1.18 times the
value at start, in any other case the upper limit depends
on the load value and is calculated as the current at start
plus 15%.

11.2.8 Emergency Off

The welding process has been interrupted by pressing the
STOP/RESET key.

11.2.9 Heater Coil Error

The dynamic current value during welding differs by more
than 15% from the required value, indicating a short-circuit
in the heater coil.

11.2.10 Power Supply Failure at Last Welding

The last welding is incomplete. The welding unit was dis-
connected from the power supply voltage while it was
in progress. To go on using the unit, this error has to be
acknowledged by pressing the STOP/RESET key (see also
Sect. 9.4).
12 Technical Specifications
Nominal Voltage
Frequency
Output Power
Ingress Protection
Primary Current
Ambient Temperature
Version May 2016
360 - 440 V (400 V) (3 P + N)
50 Hz / 60 Hz
4500 VA, 80% duty cy.
IP 54
max. 16 A
– 20°C to + 60 °C
(– 4°F to + 140°F)
HÜRNER HST 300 HP 2.0 User's Manual
25
EN