Assembly (cont.)
9
Insert one bolt (HH) into the hole in the larger portion end of one shock (K). Thread
one nut (II) onto the bolt (HH) and tighten.
Repeat for remaining bolt (HH), shock ( K) and nut Oh.
10
Paying close attention to the bend orientation of the hinge (G), insert the end of the bolt (HH)
previously installed in Step 9 into the hinge (G) as shown. Install one star locknut (GG) onto the
bolt (HH). Use a wrench to tighten locknut.
Repeat for the remaining hinge (G), shock ( K) and locknut (GG).
Orient the hinge assemblies to create one right and one left hinge configuration as shown.
11
Lower hinge to lid panel (E). Nut should nest into pocket on lid. Attach hinge to lid
panel by using six screws (AA).
Repeat with hinge on other side.
12
Insert bolt (HH) into Shock bottom. Thread nut (II) onto bolt (HH) and tighten.
Insert Bolt into lower hinge.
Repeat with hinge on other side.
8
