Parkside PLSA 40-Li C2 Traduccion Del Manual De Instrucciones Originale página 43

3. Remove the carabiner (14) from the
eyelets (20). Release the collection bag
(15) by pressing the lock button (10)
and pulling the collection bag (15) off
the blowing aperture.
4. Open the zip-fastener on the collection
bag (15) and empty it completely.
5. Mount the emptied collection bag (15)
again.
Composting material does not
belong with domestic waste!
Cleaning and
maintenance
Warning! Risk of injury by
dangerous moving parts!
Always clean the device
immediately after working with
it, as otherwise dirt will become hardened
and firmly attached with leaf residues
and might prove impossible to remove
without dismantling the motor housing.
Such cleaning work is not covered by the
warranty.
Switch off the device and remove
the battery from the device before
working with or transporting it.
You should have any repair and
maintenance work that is not de-
scribed in this instruction manual carried out
by our Service Centre. Only use original parts.
Do not use any cleaning agents or
solvents. Chemical substances may
attack the plastic parts of the device.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
Cleaning
Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
• Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush.
Do not use cleaning agents or solvents.
You may otherwise irreparably dam-
age the appliance.
• Clean the collection bag (
a brush and, if needed, compressed air.
General maintenance
• Prior to every use, check the appliance
for obvious defects such as loose, worn
or damaged parts.
• Check covers and safety devices for
damages and correct installation. Re-
place as necessary.
Removal of clogging
and blockage
Leaf material and fresh plant parts may
clog / block the device.
Cleaning the impeller wheel:
Remove the batteries from
the device! Risk of injury!
1. Open the protective cover (
remove the suction pipe (
section "Assembling/dismantling the
three-piece suction pipe" and/or "As-
sembling/dismantling the blowpipe".
2. Carefully remove residues or clogging
materials from the impeller wheel.
GB MT
15) using
A
7) or
16). See
43