Parkside PLSA 40-Li C2 Traduccion Del Manual De Instrucciones Originale página 39

Soplador/aspirador de hojas recargable 40 v
Ocultar thumbs Ver también para PLSA 40-Li C2:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 115
Remove/insert battery
1. To remove the battery (5) from the de-
vice, press the release button (5.1) on
the battery (5) and pull the battery out.
2. To insert the battery (5), push the bat-
tery (5) along the guide rail into the
device. You will hear it click into place.
Only insert the battery once
the battery-operated tool is
fully ready for use.
Assembling/dismantling
the blowpipe
Never use the leaf blower
with only one blowpipe sec-
tion attached. There is a risk
of personal injury!
Pay attention to the correct assem-
bly of the protective cover (7), oth-
erwise the leaf blower will not start.
1. Assemble the blowpipe (9) as illus-
trated. The parts click into place.
The turbo nozzle (19) can be used
optionally (see "Working with the de-
vice"). To do this, push the tab of the
turbo nozzle (19) onto the lug on the
centre blowpipe (9).
2. Now push the blowpipe (9) on to the
blowing aperture of the motor housing (1)
until the blowpipe (9) latches into place.
3. Put the protective cover (7) on the suc-
tion aperture. The marking on the pro-
tective cover (7.1) and the marking on
the motor housing (7.2) must overlap.
Push the protective cover (7) into the mo-
tor housing (1) until it clicks into place.
4. Dismantle the blowpipe (9) by pressing
the locking button (10) and pulling off
the blowpipe (9).
Assembling/dismantling
the three-piece suction
pipe
Never use the leaf vacuum
with only one suction pipe
section attached. There is a
risk of personal injury!
After the three-part suction
pipe has been assembled, it
must not be divided up again
into three parts!
Pay attention to the correct assem-
bly of the suction pipe (7), other-
wise the leaf blower will not start.
1. Open the protective cover (7) of the
suction aperture by pushing the lock
of the suction aperture (8) in the direc-
tion of the suction aperture, lifting the
protective cover and pulling the lock
(8) away from the suction aperture. You
can now remove the protective cover
(7).
2. Assemble the three suction pipes (16)
as illustrated.
When assembling, pay attention to
the guide grooves on the suction pipe
parts.
3. Place the suction pipe (16) on the suc-
tion aperture in the working direction.
The suction pipe (16) can only be
mounted in the correct working direc-
tion. Push the suction pipe (16) into
the motor housing (1) until it clicks into
place.
4. Dismantle the suction pipe (16) by
pressing the lock of the suction aperture
(8) in the direction of the suction aper-
ture, lifting the suction pipe (16) and
then pulling the lock away from the suc-
tion aperture (8).
GB
MT
39
loading