Product Identification; Monitor Panel; Installation Location; Electrical Requirements - Technibel Climatisation SCD106C5TA Serie Instrucciones De Uso

PRODUCT IDENTIFICATION

01 Infrared rays remote control unit
02 Air filter handle
03 Air outlet

04 Monitor panel

05 Quick coupling cover
06 Outdoor unit
07 Outdoor unit basket or support
08 Flexible tube
09 Air intake
10 Electric cable with plug
MONITOR PANEL
1 3 4
TEST OFF ON
6 5
1. Timer lamp: this lamp lights when the system is being controlled
by the timer.
2. STAND-BY lamp: this lamp lights:
At the beginning of the warm up period (till the heat exchanger
of the indoor unit has warmed up sufficiently).
During the warm up period, when the thermostat stops the
compressor.
During the warm up period when the defrosting system of the
outdoor unit is operating.
3. Operation lamp: this lamp lights when the air conditioner is
running.
4. Receiver: this section picks up signals from the infrared rays
remote control unit (Transmitter).
5. Operation selector.
ON Position: in this position the air conditioner is operating
and controlled by the remote control unit. Normally the selector
must be in this position.
OFF Position: switch the selector to the OFF position if you are
not going to use the air conditioner for a few days or longer.
WARNING
The OFF position does not disconnect the power. Use the
main power switch to turn off power completely.
CAUTION
TEST Position: This position is used only by Service techniker
for servicing the air conditioner, so don't leave the selector in
this position during normal operation.
6. Water-level alarm: this lamp flashes and the air conditioner
simultaneously stops during exceeding condensate drainage
or because of malfunctioning of the condensate drainage
system.
7
COOLING Model Only
3
2
1
10
1 2 3 4
TEST OFF ON
6 5

INSTALLATION LOCATION

We recommend this air conditioner to be installed properly
by qualified installation technicians in accordance with the
installation instructions provided with the unit.
WARNING
Do not install this air conditioner where there are fumes
or flammable gases, or in an extremely humid space
such as a green house.
Do not install the air conditioner where excessively high
heat-generating objects are placed.
Do not install the air conditioner where the atmosphere
is extremely damp or humid (e.g. greenhouse or laundry)
it could be wetted by drops of water (i.e. in laundries).
Avoid:
To protect the air conditioner from heavy corrosion, avoid installing
the outdoor unit where salty sea water can splash directly onto
it or in sulphurous air near a spa.

ELECTRICAL REQUIREMENTS

Before using the appliance
Check that the power supply at the location where the air
conditioner is going to be used is 220/240 volt, single phase.
The air conditioner cable is M model code 6702000013 In case
of replacement, please contact the After Sales Service.
Before connecting the air conditioner to a power socket,
make sure that the socket is provided with an earth
connection.
Verify that the available power supply is sufficient for running other
electrical domestic appliances in use simultaneously from the
same supply. See the data plate on the unit showing the max.
absorbed powers.
3
4
9
COOL / DRY / HEAT Model Only
5
6
EG
8