UL is an internationally
recognized
safety
organization.
The UL Mark on the product
means
it has
been UL Listed.
If you haw, aW questions about this
product, you may call:
SoW Customer Infi)rmation Center 1-800-
222-SONY (7669).
The number below is f;_r the FCC related
matters o111}:
RegulatoryInformation
Declaration of Conformity
Trade Name: SONY
Model No.: HDR-CX550V
Responsible Party: Sony Electronics Inc.
Address: 16530 Via Esprillo, San Diego,
CA 92127 U.S.A.
Telephone No.: 858-942-2230
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
f;)llowing two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept any
interfk,rence receiw, d, including
interfk,rence that may cause undesired
operation.
Declaration of Conformity
Trade Name: SONY
Model No.: HDR-XR550V
Responsible Party: Sony Electronics Inc.
Address: 16530 Via Esprillo, San Diego,
CA 92127 U.S.A.
Telephone No.: 858-942-2230
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
f;)llowing two conditions: (1) This device
may not cause harmful interference,
and (2) this device must accept any
interfk,rence receiw, d, including
interfk,rence that may cause undesired
operation.
CAUTION
You are cautioned that any changes or
modifications
not expressly approved in
this manual could w_id your authority to
operate this equipment.
Note
This equipment has been tested and f;mnd
to comply with the limits fi_r a Class B
digital device, pursuant to Part 15 of the
FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and
can radiate radio frequency energy and,
if not installed and used in accordance
with the instructions,
may cause harmful
interference to radio communications.
Howew, r, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined
by
turning the equipment off and on, the
user is encouraged to try to correct the
interference by one or more of the ti_llowing
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on
a circuit different f¥omthat to which the
receiver is connected.
- Consult the dealer or an experienced radio
TV technician *brhelp.
The supplied interface cable must be used
with the equipment in order to comply with
the limits fi_r a digital device pursuant to
Subpart B of Part 15 of FCC Rules.