Idiomas disponibles
Idiomas disponibles
Electronic Alert & Diagnostic System
NORMAL
DOOR )PEN
Q
WARMTEMP
D
i
pF POWER
dE DEFROST
FF FREEZ£R
£t ICE MAK_
. .........
J
i
SYSTEM
CHECK
RESET
Kenmore
CUBE0
1
rIDOoR M]
j
J oN/oj
(_ Red signal light flashes to tell you when either door
is open_
(_) Signal light tells you that the Door Alarm beeper has
been set to sound after either door has been open 30
seconds..
(_) Red signal light tells you when freezer foodkeeping
temperature is above normal.
(_ Lighted word NORMAL indicates that no failure has
been detected by the diagnostic system
(_) Flashing diagnostic codes in the display
warn you when:
_
power has been interrupted.
_
defrost system has failed.
I_
frozen foods should be checked.
i
icemaker may not be operating properly.
What these codes mean-and
what to do when they
appear-is
summarized on the inside of the freezer
compartment door and explained
more thoroughly
on the following pages..
(_ SYSTEM CHECK-RESET pad puts a review of
the electronic diagnosis of four coded functions
at your fingertip and also allows you to erase codes
from display.
Electronic control allows you to select ice cubes,
crushed ice or chilled water and signal light confirms
your choice.
When your refrigerator is first plugged inn,,,
All panel lights come on for five seconds, a beep sounds,
and lights go off except as follows:
" PF flashes in the display. Touch SYSTEM CH ECK-RESET
pad to erase it,
" Word NORMAL
glows.
• Red WARM TEMPERATURE light glows if freezer
compartment temperature is higher than normal. It goes
off when proper foodkeeping
temperature is reached.
" Door alarm beeper is activated and light on DOOR
ALARM pad glows.
• CRUSHED ICE selection light glows
Red DOOR OPEN light flashes if either door is open,
goes out when doors are shut°
• Night light in water-and-ice dispenser is off,
