Idiomas disponibles
Idiomas disponibles
Drawer Removal
Drawers will stop before
coming all the way out of the
refrigerator to help prevent
contents from spilling onto
the floor. Drawers can easily
be removed by tilting up
slightly and pulling past
"stop" location,
On some models you may
need to remove the door
bins from the fresh food door
before removing the drawers
Drawer H_J_
guide7
!
When replacing the drawers
make sure you slide them
through the drawer guides
on the left side.
tf the door prevents you from taking out the drawers, the
refrigerator will need to be rolled brward
until the door
opens enough to slide the drawers out. In some cases
when you roll the refrigerator out you will need to move
the refrigerator to the left as you roll it out
Drain Opening
in Freezer Compartment
When cleaning, remove
!
the freezer bin and flush a
solution of baking soda (one
teaspoon [5 roll) and two
cups (500 ml) of hot (not
boiling) water through the
drain line with the help of a
meat baster, This will help
eliminate odor and reduce
the likelihood of a clogged drain line,
If drain becomes clogged, use a meat baster and baking-
soda_and-water solution to force the clog through the
drain line.,
Behind Refrigerator
Take care moving your refrigerator away from the wall.
All types of floor coverings can be damaged, particularly
cushioned coverings and those with embossed surfaces.
Pull the refrigerator straight out and return it to position by
pushing it straight in. Moving refrigerator in a side
direction may damage floor covering or refrigerator,
When pushing the refrigerator back, make sure you don't
roll over the power cord or icemaker supply line,,
U nd er Refrigerator
The condenser is located
behind the base grille For most
efficient operation, remove the
base grille (see page 3) and
sweep away or vacuum up
dust that is readily accessible_
For best results, use a brush
specially designed for this
purpose, It is available
at your
Clean the condenser coils
at least once a year
Sears store or service centen This easy cleaning
operation should be done at least once a year,
t5
Light Bulb Replacement
Unplug refrigerator before changing a light bulb.
Fresh Food Compartment-Upper
Light
1, Pull off temperature
control knobs,
Pin
2. Pull the bottom of the
light shield down and
forward, then rotate the
top up and off,
After replacing with
same size bulb, reinstall
light shield,
Fresh Food Compartment--Lower
Light (on some models)
This light is located behind the top drawer or right above
the top drawer (depending on your model),
1, Unplug the refrigerator,
2. If the light is behind the top drawer you will need to
remove the drawer and the shelf above it,,To remove the
drawer see the Drawer Removal section in Care and
Cleaning,
• To remove the shelf first
remove any food on the shelf
Then tilt the shelf up at the
Front and lift it up and out
of the tracks,
3o Grasp the bottom of
the light shield and pull it
forward and up.
4. After replacing with the same size bulb, replace the shield.
If you cannot locate the correct bulb, see your dealer
5_ Ifthe tight was behind the top drawer, you wil! need to
replace the drawer and the shelf above it,
• To replace the shelf, raise the shelf front slightly and
place the top hooks in the lowest large track slots. Then
lower the front of the shelf until it is level,
6. Plug the refrigerator back in
Freezer Compartment
1. Remove shelf just below light
panel, (Shelf will be easier to
remove if it is emptied first,)
2. Pul! plastic light panel
1!_
toward you (It wil! bend to free tabs from grooves,)
3. After replacing with same size bulb, reinstall panel
and shelf,
Convenience
Center
1. Remove top door bin and
raise Convenience Center
inner door,
2. Press sides of flexible light panel to release locking
tabs and allow the panel to swing down
3. After replacing with nightJight bulb of same wattage,
place rear tab of light panel into door and rotate panel
up until tabs lock into slots above,
