Operation Modes; Mitre Cuts; Sliding Cuts - Zipper Maschinen ZI-KGS255DS Instrucciones De Servicio

15.3 Operation modes

15.3.1 Mitre cuts

Mitre are particularly suitable for cutting small workpieces (approx. 100 mm) to length.
 For cross-cut cuts, the sliding mechanism is fixed by the fixation screw (23) so that the saw unit
cannot slide forwards or backwards during the cut.
 Adjust the angle setting according to the desired operation and adjust the stops/fences
accordingly.
 Mark the cutting line (by laser).
 Place workpiece against stop/fence and table and fix with the clamp device.
 Move the machine head to the uppermost position.
 Switch on the machine and wait until the saw blade has reached full speed (approx. 5 sec.),
 Make the crosscut (move the machine head downwards) until it has reached the lowest position.
 Move the machine head to the uppermost position.
Machine head is spring loaded, do not simply release the machine head, instead
move the handle upwards until the uppermost position is reached (rest position).
 Release the ON-OFF switch and wait until saw blade comes to stand still.
 Remove workpiece

15.3.2 Sliding cuts

Sliding cuts are suitable for cutting longer workpieces.
 For that kind of cuts, the sliding mechanism is unlocked by releasing the fixation screw (23) so
that the saw unit can slide forwards or backwards during the cut.
 Adjust the angle setting according to the desired operation and adjust the stops/fences
accordingly.
 Mark the cutting line (by laser).
 Place workpiece against stop/fence and table and fix with the clamp device.
 Move the machine head to its uppermost position and pull the machine head towards you.
 Switch on the machine and wait until the saw blade has reached full speed (approx. 5 sec.),
 Make the cut (move the machine head downwards) until it has reached the lowest position and
then slowly push the machine head backwards to be able to machine the wide workpiece over
its entire length.
 Move the machine head to the uppermost position.
Machine head is spring loaded, do not simply release the machine head, instead
move the handle upwards until the uppermost position is reached (rest position).
 Release the ON-OFF switch and wait until saw blade comes to stand still.
 Remove workpiece
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
NOTE
NOTE
OPERATION
31
ZI-KGS255DS