Operation; Initial Check Before Start; Locking / Unlocking The Machine Head In The Transport Position; Setting The Angular Position Of The Worktable - Zipper Maschinen ZI-KGS255DS Instrucciones De Servicio

15

OPERATION

15.1

Initial check before start

 Check that the speed of the machine is lower than the max. permissible speed of the saw
blade used.
 Check saw blade rotation and saw blade dimensions to match the machine.
 Check that the saw blade guard works properly.
 Check whether the connection to a dust collection system is installed.
 Check whether the stops/fences are set correctly and the saw blade is tightened.
 Check whether the machine is fixed on the working plate or a machine stand.
15.2 Operation

15.2.1 Locking / unlocking the machine head in the transport position

By slightly pressing down the machine head (34) and simultaneously removing the locking bolt
(11) from the motor holder, the saw is released from the lowest /transport position.
Note: Please hold the handle and guide the machine head slowly upwards until it reaches the
uppermost position. If the handle is released, the machine head will jump up due to the spring
preload. Press the machine head (34) downwards to engage and reattach the locking bolt (11).

15.2.2 Setting the angular position of the worktable

15.2.3 Setting the angular position of the machine head

ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
Release the locking lever (6) when it is
tightened, pull the locked position lever (7)
upwards and adjust the rotary table (32) with
the locking lever (6) to the desired angle.
The angular position is indicated by a pointer
(33) on the turntable.
Return the locking lever (6) to the closed
position to secure the rotary table (32).
Loosen the fixing screw (1).
Turn the machine head (34) with the handle
(14) to the left until desired angle value on the
scale (10) is reached.
Then tighten the fixing screw (1) again.
OPERATION
29
ZI-KGS255DS