Kenmore 24 Manual Del Propietário página 9

Installlng and Removing Previously
Insta_aed Decorator Panels
In older to remove the decorator panels and replace
with new panels you need to remove the handles. A
T-20 Torx driver is needed_
Removing the Handles:
I. Loosen
and remove the 2 screws in the Top Trim.
2. Loosen and remove the 2 screws in the bracket that
attach the Handle to the top of the Door.
3. Grip the Handle firmly and slide upwards. The
keyhole slots on the Handle slide off the buttons
on the Door.
4. Open the Door and slide out the decorator panels.
Inserting the Door Panels:
Before installing the decorator panels, make sure they
have been routed out in the proper areas as shown in
the beginning of this section. Slide in the panels to
perform a trial fit before fastening down the Handle
and Top Trim.
Installing the Handles:
Once the panels are fitted properly, insta!l the Handle
and Top Trim.
!. Slide the keyhole slots on the Handle down onto
the buttons mounted to the face of the Door. Slide
the Handle downward until the bracket at the top
of the Handle fits flush on the top of the Door.
2. Replace the two screws in the bracket that attach
the Handle to the top of the Door and tighten
the screws to 45 in-lbs torque.
3. Replace the Top Trim ma!dng sure it fits over the
Side Trim and that the locating tabs fit the inside
of the Handle profile.
4. Replace the Top Trim screws and tighten to r30
in-lbs torque.
Bu_ons (
Bu_on
Top Trim Screws
- Bracket Screws
Bracket
Slots