Idiomas disponibles
Idiomas disponibles
Refrigerator
gnstaHation
Door
Alignment
After leveling, make sure that
the doo_s are even at the top.
Hake sure door's
are even at the top
m
Uneven Doors
To make
the doors
even, adjust
the flesh
food door_ Insert
a
3/16"
Allen wrench
into the bottom
of
the hinge pin. Turn
the door adjusting
screw to the right to
raise the door, to the left to lower it. (A nylon
plug,
imbedded
in the threads
of the pin, prevents
the pin
from turning
unless
a wrench
is used°) After one or
two turns
of the wrench,
open and close rile fresh food
door and check the alignment
at the top of the doors.
Trim
Kits and Decorator
For
Built-In
models
Some models a_e equipped with trim Idts that allow you
to install door panels° You can order pre-cut black or'
white decorator panels from your Seais Service Center, or
you can add wood panels to match your kitchen cabinets°
Panels Less Than
! 14" (6 mm) Thick
When installing wood panels less than 1/4" (6 ram)
thick, you need to create a filler pane!, such as 1/8"
cardboard,
that will fit between the face of the door
and the wood panel. If you are installing the pre-cut
decorator panels, pre-cut filler panels are included in
the Idto The combined
thiclmess of the decorator or
wood panel and the filler panel should be 1/4" (6 mm)o
Care of Pre-Cut
Panels
Cleaaa these panels using an anti-static cleaner or a
mild detergent and water° (Look for' anti-static cleaner
in electronic or computer' departments°)
Rinse
thoroughly
and blot dry with a clean, damp cloth or
chamois° Do not use paper towels to wash or dry the
panels. Do not use cleaners that contain solvents, such
as ammonia,
because they can damage the panels.
Shallow scratches arid abrasions can be corrected with
a good grade of hard automobile
paste wax° Do not
use a cleanedwax
combination.
The wax wil! fill in any
minor surface scratches and will help to maintain the
luster of the panels. Apply the wax sparingly and buff
lightly with a clean, soft cloth using a circular motion.
Panel Installadon
314" (19 mm)
or Raised Panel
A raised panel
design
screwed
or glued to a I/4"
(6 ram) thick bactdng,
or a 3/4"
(t9 mm) routed
board
can be used. The raised portion
of the panel
must be fabricated
to permit
clearances
of at least 2"
(51 ram) from the handle
side for fingertip
clearance.
Weight
limitations
for custom
panels:
Fresh Food:
35 lb. (I6 kg) max,
Freezer Door: 25 lb. (11 kg) max.
2" (51ram) ! 111 ! 1
_,__
"
Clearance
I ! IIII
-'_.-_'_"_"
Appearance
I
_
.,_-_"_
qTilII
1/4" (6 ram)
Thick Backing
_8/4"
(19 mm)
Refrigerator
Door
