Kenmore 24 Manual Del Propietário página 8

Idiomas disponibles

Idiomas disponibles

Inserting
the Door
Panels
!. Loosen the Top Trim on the freezer and fresh
food doors.
* Using
a T-20 Toix driver, loosen
the two screws
attaching
the Top Trim about
1/4" (6 mm)_
2. Insert
the panels.
o Lift the Top Trim up 1/4" (6 mm) and carefully
push
the top freezer panel in until
it slides into the slot
behind
the door handle,
Push the fillet panel
(requiied
with some door panels)
in behind
the
decorator
panel
Repeat
for flesh food panel. If your
model
has a dispenser
andlor
a Convenience
Center;
this step only applies
to the top panels,
3. Insert
the bottom
panels
(for models
with
a
dispenser
and/or
Convenience
Center).
- Carefiflly
push the panel in until it slides into the slot
behind
the door handle_ Push the filler panel (required
with some door panels) in behind
the decorator
panel,
4. Tighten
the two screws
on the Top Trim
to 30
in-Ibs torque.
5, Install
the Side Trim.
These
pieces are tucked
inside the flesh food door handle,
Do not remove the protective film on the outside
of the Side Trim until the Side Trim is installed,
• Fit the bottom
of the Side Trim under
the Bottom
Trim
as illustrated,
o Hold
the Side Trim against
the fiont face of the
decorator
panels and fit the Side Trim under
the Top
Trim, Make sure the Side Trim is fitted correctly
and
that you are satisfied
with the appearance
of all the
parts before
pulling
the blue tape liner,
6. Secure
the Side Trim.
• Place one hand between the two pieces of blue tape
liner and hold the Side Trim firmly against the panels
and the side of the door.
• Pull the top blue tape liner up about 3" (8 mm),
pressing the trim with your hand as the adhesive is
exposed to the door. Then pull the bottom blue tape
liner down about 3" (8 mm), Follow the tape with
your hand, pressing the trim adhesive against the door.
° Continue
pulling the tape liner loose, alternating
between the top and bottom and pressing the Side
Trim against the dooi:
7. Remove the protective
film from the outside of
the Side Trim.
Blue
Tape
Liner
Side
Trim
Cut-Out
4
Side
Trim
loading

Este manual también es adecuado para:

2830