Idiomas disponibles
Idiomas disponibles
USER'S MANUAL. PROLINK-4
6 MAINTENANCE
6.1
Internal fuses which user cannot replace
The following fuses are found on the base board. Their location identifier and
characteristics are the following:
F001 and F002
6.2
Replacing the Battery
Battery must be replaced whenever the capacity of the fully-charged battery is
noticeably diminished. To change the battery, follow next procedure:
Remove the rear holster, if in place.
-
The battery compartment is located in the rear panel of the instrument. Remove
-
the securing screw (A) and washer from the compartment cover as shown in
the previous figure (it shows the battery compartment once the cover and
connector linking the battery to the board have been removed).
Disconnect the battery connector strip from the board, and replace the battery
-
with a new one of the same characteristics.
The configuration data and all data stored in the memories will be lost when the battery
is disconnected.
-
Place and connect the battery to the board using the connector.
02/2003
7 A
Figure 53.- Battery compartment.
S
125 V
SMD
IMPORTANT NOTICE
Page 97
