Foppapedretti Street Manual De Instrucciones página 41

• ENGLISH •
USE IN THE VEHICLE
INSTALLATION IN THE FORWARD-FACING POSITION (Children between 100 and
150 cm in height, 3-point seat belt or ISOFIX + 3-point seat belt)
It is recommended that you use the 5-point harness for as long as possible. When the
growing child reaches a height of 100 cm, the car seat must be transformed for use
with children between 100 and 150 cm in height. In this configuration, it is necessary to
remove the 5-point seat belt (harness) supplied with the car seat.
See paragraph "REMOVING THE HARNESS (Storing the safety harness away)".
Only suitable for use in vehicles equipped with 3-point static or retractor seat belts,
approved according to regulation UN/ ECE no.16 or other equivalent standards.
Mode B1 - INSTALLING WITH 3-POINT SEAT BELT TOGETHER WITH ISOFIX
CONNECTORS
Press both sides of the adjustment/release button on the ISOFIX connectors
simultaneously and extend the ISOFIX connectors (fig. 29)
Locate the ISOFIX attachments supplied with the vehicle (fig. 30).
If your car does not have standard ISOFIX connector guides, insert those supplied with
the car seat, see paragraph "How to install the ISOFIX system" .
Align the ISOFIX connectors with the anchoring points fixed to the vehicle passenger
seat and press until you hear a "click". The indicator on both brackets will turn green,
confirming that they have attached (fig. 31).
Ensure that both brackets are correctly fastened.
Push the car seat against the passenger seat, making sure that both ISOFIX connectors
are extended in the same position. Shake the car seat to be sure it is correctly fixed in
place. There must not be any space between the backrest of the passenger seat and
the car seat (fig. 32).
Place the child in the ar seat (fig. 33) and adjust the height of the headrest according to
the size of the child (see "Adjusting the headrest").
Secure the child with the 3-point seat belt supplied with the car, passing the diagonal
belt of the vehicle through the upper belt guide loop (A) and the lap belt of the vehicle
through belt guide loops (B) and (C) (see figure 34).
Clip the buckle, a "click" will indicate that it is correctly fastened (fig. 35).
WARNING! The vehicle's seat belt buckle must not be placed in the lower guide of the
lap belt passage.
Insert the diagonal belt and the lap belt into the lower loop from the side near the
fastening buckle of the vehicle's seat belt (C).
Thread the lap belt on the opposite side of the car seat into the lap belt loop (B).
WARNING! The lap belt must Street as low as possible over your baby's pelvis.
Insert the diagonal belt into the belt guide loop (A), making sure it is not twisted.
41