Selecting A Measurement Mode; Navigating Between Menus; Navigating Within A Menu; Using The Alphanumeric Keypad - Mettler Toledo SevenCompact S220 Instrucciones De Manejo

4.5 S electing a measurement mode
Press the MODE softkey to switch between the different measurement modes.
The sequence of the alternating measurement modes is:
1. pH
2. mV
3. rel. mV
4. ion
4.6 N avigating between menus
The meter display consists of a measurement frame, softkeys, areas for status icons and under l y-
ing menu areas.
To access the menu areas and to navigate between them, use various softkeys (see "Using the
soft k eys").
●
Press Menu.
The Setup menu appears and the pH/Ion tab is highlighted.
●
Press to highlight the Setup tab, or
●
Press to highlight Sensor ID / SN.
●
Press EXIT to return to the measurement screen.
4.7 N avigating within a menu
This example is based on the Setup menu, but the procedure applies to the other menus as well.
●
Press Menu.
The Setup menu appears and the pH/Ion tab is highlighted.
●
Press as often as needed to navigate to a menu item.
●
Press Select to move deeper in the menu for the chosen operation.
●
Continue navigating with
the menu.
●
Press MODE/EXIT to go back to the previous menu.
— or —
●
Press READ to return to the measurement screen directly.
4.8 U sing the alphanumeric keypad
4.8.1 A lphanumeric input
The meter has a screen keypad for entering IDs, SNs and PINs. Both numbers and letters are al-
lowed for these entries.
When entering a PIN, each character entered will be displayed as ( * ).
, or Select until the final destination is reached within
Operating the meter 17