Idiomas disponibles
Idiomas disponibles
Maintenance
Keep the washer clean to prevent deteriorated performance and to preserve its life cycle.
WARNING
Certain internal parts are intentionally not grounded and may present a risk of electric shock only during
servicing. Service personnel – Do not contact the following parts while the appliance is energized: Control
board, heat sink, motor, inlet valve and pump.
Self Clean+
Certain usage and environmental conditions may result in some residue build-up or odor in the washer
drum. To prevent this build-up or odor and keep your washer drum fresh and clean, perform the Self Clean+
cycle at least once a month or every 40 cycles. Perform the recommended procedure below when using the
Self Clean+ cycle.
1. Tap
.
2. Turn the Navigation dial to select Self Clean+.
3. Tap and hold
.
CAUTION
If there is chlorine bleach left in the washer drum for an extended period of time, rust can occur.
NOTE
• The water temperature for Self Clean+ is defaulted to Extra Hot. This temperature cannot be changed.
• In the case where residue is present in the washer drum, add liquid chlorine bleach to the MAX level
line in the main-wash compartment before starting the Self Clean+ cycle. Do not add the liquid chlorine
bleach to the bleach compartment (This is only the case for Self Clean+ cycle).
• Do not exceed the max line. Do not use or mix any other detergent or chemicals during the Self Clean+
cycle. If necessary, run a Rinse+Spin cycle after the Self Clean+ cycle has completed to help remove any
remaining residue.
Self Clean+ reminder
• After every 40 cycles, the washer displays the "Remove laundry and hold
for an hour to alert you to run the Self Clean+ cycle.
• It is recommended to run the cycle regularly for hygienic purposes.
• You will see the Self Clean+ alert message when the washer completes a cycle. If you open the door, the
message disappears, and the display shows the Self Clean+ cycle setting screen automatically. At this
time, the dryer control panel displays the recommended drying cycle.
• The reminder will appear on the control panel for 5 additional consecutive cycles before turning off. The
next reminder will not appear until another 40 cycles have been completed.
50
English
Untitled-1 50
to clean washer" message
2022-04-11
12:23:47
