Idiomas disponibles
Idiomas disponibles
EN
Press the button to turn the plane.
The planer stops spinning as soon
as you release the button. If the
button is pushed after the trigger
has been pulled the switch blocks
even if the trigger is treleased. The
launch button is switched off after
releasing the trigger.
Before connecting your
NoTE:
machine, make sure the operating
button is loose and the trigger
back to its original position when
released.
PLANNING THE
oPErATIoN
First, place the base on a front
surface or workpiece, but do not
let it touch the blade. Connect
button and wait until it reaches
full speed. Then gently move the
machine forward. When starting
operation, make power at the front
of the machine. Force the back of
the machine when you finish the
job. The cutting speed and its depth
determine the effect of the process.
To gain procedural effect, reduce
the depth of cut and move the
machine more smoothly.
To make a cut in trapeze, please use
the stop edge.
Draw a line on the workpiece. Insert
the stopper in the front hole, then
align the stop edge with the cut line.
ON
blade extremity
cutting line
Adjust the stop edge until it touches
the edge of the piece. Then tighten
the screw.
screw
If you want to increase the length
of the stop, you add an extra piece
of wood. For this operation, the
holes will be opened on the anvil.
These holes will also be used if you
want to lengthen the guide (choose
accessory)
NoTE:
align the anvil edge with the edge
of the piece before moving the
machine. The maximum depth of cut
is 9mm (11/32 ").
PLANNING THE ANGLE
To make a cut as shown in the
figure, please align the slot "V"
situated at the front with the edge of
the workpiece, after making a plane
as shown in Fig.
stop
When planning, please
slot "V"
front base plate
15
15
