Idiomas disponibles
Idiomas disponibles
EN
Specifications may be subject to
change without notice.
Specifications may differ
NoTE:
from country to country.
mAIN SAFETY ruLES
NoTE: Please read the following
instructions before operating any
electrical machine:
1. Keep the workplace clean. Do not
use power tools in places untidy.
2. Pay attention to the workplace.
Do not operate power tools in wet
locations. Keep them away from
rain.
3. Keep children and bystanders
away from your job. Do not work
with the machine.
4. Store the tool when not using it
and do it in a dry, safe place.
5. Do not force your machine.
It is safer to use it within their
capabilities.
6. Use the right tool and proper to
the work you do.
7. Never wear loose clothing while
working. When working abroad,
we recommend the use of rubber
gloves and shoes without holes. It
is also recommended the use of
protective helmets.
8. Wear safety goggles and a mask
appropriate if there is too much
dust.
9. Do not carry the appliance by the
cord. Keep cord away from heat,
sharp objects or greasy.
10. Secure the machine. It is safer
to work with the machine with fixed
clamps.
11. During operation, maintain a
correct posture.
12. Preserve the machine. To
achieve best results, keep the blade
sharp. Check the wire. Keep the
handle dry and clean.
13. When not using the machine or
when you are changing the blade,
make sure to shut off the current.
14. Remember to remove any key
before starting the machine. Always
make sure the adjustment tools
were removed.
15. Avoid unexpected starts. Before
connecting the machine to the
mains, check the button.
16. Use an extension for work
abroad.
17. Do not use the machine if you
feel tired.
18. Check for damaged parts.
Before using your machine again,
carefully check the coverage or
any part is damaged. Make sure all
moving parts are in their positions.
If any problem with the button
should send the machine to a local
expert.
19. Avoid electrical shock. During
the operation, your body should
not touch grounded metal, such as
pipes, tubes.
20. Replace parts, using only
identical pieces and origin.
Caution: when connecting the
machine to the mains, make sure
that the voltage is indicated on
the nameplate of the machine. If
different than indicated, will damage
the machine. So do not plug without
first check the voltage.
AddITIoNAL ruLES For
ELECTrIC PLANEr
1. Do not let clothing, wires etc. in
the workplace.
2. Check carefully for nails or
pieces of stone on the workpiece.
3. Before starting work you should
check the blade bolt is tight.
4. Transportation blade carefully.
5. Hold the camera with both hands.
6. Keep hands away from rotating
parts of the machine.
7. Before using the machine, make
it run a bit. Make sure that vibrates
or twists.
8. Make sure that the blade does
not touch the workpiece before
starting the machine.
9. After connecting the machine to
start its work when it reaches full
speed.
10. Keep your body away from the
machine at least 200mm (8 ").
11. Make adjustments until the tool
stops rotating altogether.
12. Do not clean the wooden flap
with your finger. Do it with a piece
of wood.
13. Do not let the rotate tool.
Follows it with both hands.
14. When landing your plane power,
unplug the AC power cord and put
it on blocks of wood with the blade
facing backwards.
Please keep these instructions.
13
