Connecting Stop Switch Wires; Connecting Throttle Cable - Maruyama E30S Manual Del Propietario U Operador

Connecting Stop Switch Wires

Shaft Grip
Stop Switch Wires
Stop Switch WIres
1. Install the plastic tube (packed with the drive shaft
assembly) around the throttle cable and stop
switch wires.
2. Plug the stop switch wires into the matching
connectors from the engine. Note that wire
polarity is not important.
Plastic Tube
Throttle Cable
Knob
Air Filter Cover
— US-13 —

Connecting Throttle Cable

Cable Adjuster Sleeve
Throttle Cable Housing
Carburetor Bracket
Cable Adjuster
Sleeve
Carburetor Throttle Cam
Slotted Fitting
1. Loosen the knob and remove the air filter cover,
insert the throttle cable through the cable adjuster
sleeve on the carburetor bracket. Make sure the
end of the cable housing is seated positively in the
sleeve.
2. Position the slotted fitting on the carburetor so the
recessed hole for the cable lug is away from the
cable adjuster sleeve.
3. Rotate the carburetor throttle cam clockwise and
slip the throttle cable through the slot in the
slotted fitting, making sure the cable lug drops
into the recessed hole.
4. Operate the throttle trigger a few times to make
sure that it works correctly.
5. Adjust the cable adjuster sleeve so the stop on the
carburetor throttle cam just contacts the throttle
stop when the throttle trigger is fully depressed.
Locknut
Throttle Cable
Slotted Fitting
Recessed
Hole
Cable
Lug
Throttle Stop/Idle Speed
Adjuster Screw Bracket
Idle Speed
Adjuster Screw