Assembly; Assembling Engine And Drive Shaft Assembly; Loop Handle Installation; Connecting Throttle Cable And Stop Switch Wires - Maruyama P23 Manual Del Operador

Assembly

Assembling Engine and Drive
Shaft Assembly
The drive shaft, clutch drum housing and gearcase are
assembled. Attach the clutch drum housing to the engine
using the four M5 x 20 screws supplied with the unit.

Loop Handle Installation

The loop handle kit contains a package of four screws and
nuts and the bottom clamp for the loop handle.
Screw (4)
Nut (4)
1. Place the loop handle and the bottom clamp on the
shaft approximately 28cm(11 inches) from the end
of the stop switch/throttle trigger assembly.
2. Install the four screws and nuts. Leave the screws
fingertight.
Engine
M5 x 20 Screw (4)
Shaft
Clutch Drum Housing
Loop Handle
Bottom Clamp
3. Reposition the loop handle up or down the driveshaft
to the most comfortable position, but no closer than 9
inches (22.8 cm) from the end of the stop switch.
4. Tighten the screws and nuts.
Connecting Throttle Cable and Stop
Switch Wires
1. Loosen the knob and remove the air filter cover, insert the
throttle cable through the carburetor bracket, then screw
a cable adjuster sleeve into the carburetor bracket fully.
2. Position the slotted fitting on the carburetor so the recessed
hole for the lug is away from the cable adjuster sleeve.
3. Rotate the carburetor throttle cam and slip the throttle cable
through the slot in the slotted fitting, making sure the cable
lug drops into the recessed hole.
― US - 12 ―
Cable Adjuster Sleeve
Throttle Cable
Carburetor
Bracket
Slotted Fitting
Cable Lug
Lock nut
Recessed Hole