Setting Depth Of Cut; Maintenance; Idle Speed Adjustment - Maruyama E30S Manual Del Propietario U Operador

Increase the
Depth of Cut
Shield
Knob
7. Make sure the blade is rotating (at least half
throttle) before inserting the blade into the cut.
The Edger performs best at full throttle.
8. Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
9. Stop the Edger engine when moving between
work sites.
k
CAUTION
• Always wear gloves and protective
clothing when operating the Edger.
• If the Edger blade becomes jammed, stop the
engine immediately.
• Make certain all moving parts have stopped and
disconnect the spark plug before inspecting the
equipment for damage.
• Never use a Edger that has chipped, cracked or
broken Edger blade or blade shield.

Setting Depth of Cut

IMPORTANT: Set the depth of cut before you
start the engine.
1. Loosen the knob holding the shield to the plate.
2.
Decrease the
Depth of Cut
3.
Wheel

Maintenance

Maintenance, replacement or repair of emission
control devices and systems may be performed by
any repair establishment or individual; however,
warranty repairs must be performed by a dealer or
s e r v i c e c e n t e r a u t h o r i z e d b y M a r u y a m a
Manufacturing Company, Inc. The use of parts that
are not equivalent in performance and durability to
authorized parts may impair the effectiveness of the
emission control system and may have a bearing on
the outcome of a warranty claim.
Maintenance on today's low-emission engines is
even more critical for longest life and best
performance. particularly critical are air and fuel
filters, spark plug heat range, cooling air intake
area and proper gaps of coil and plug.

Idle Speed Adjustment

This Edger is equipped with non-adjustable fuel
mixture carburetor. The engine idle speed is the only
adjustment for the operator.
• I d l e s p e e d a d j u s t m e n t s h o u l d b e
— US-20 —
Rotate the shield as necessary to set the depth of
cut. Note that:
• Rotating the shield to raise the wheel increases
the depth of cut.
• Rotating the shield to lower the wheel
decreases the depth of cut.
Make sure the shield is positioned to protect the
operator from thrown debris, then tighten the
knob.
k
WARNING
checked each time the unit is operated.