Installing Shield; Installing Edger Blade - Maruyama E30S Manual Del Propietario U Operador

6. When the throttle cable is adjusted correctly,
tighten the locknut.
7. Reinstall the air filter cover and tighten the knob.

Installing Shield

k
WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by the
Edger.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injur y.
HOW TO AVOID THE HAZARD
• Never operate the Edger without the
debris shield in place.
Shield Stud
Debris Shield
Hex Nut
Lock
Washer
Flat Washer
Spacer
Plate Stud
1. Install the spacer onto the plate stud.
2. Install the shield onto the plate stud, making sure
the shield stud fits into the matching slot in the
plate.
3. Install the flat washer, lock washer and hex nut
onto the plate stud.
4. Install the flat washer and knob onto the shield stud.
Plate
Flat Washer
Knob
— US-14 —

Installing Edger Blade

k
CAUTION
POTENTIAL HAZARD
• If the Edger blade is not adequately
tightened, it can come loose from the
Edger during use.
WHAT CAN HAPPEN
• This may cause damage to property or
personal injur y.
HOW TO AVOID THE HAZARD
• Make sure the Edger blade is securely
fastened to the attaching shaft in the
gearcase.
3 mm Hex Wrench
Blade Bolt
(left hand thread)
Clamping Washer
1. Install the boss adapter and the collar onto the
attaching shaft out of the gearcase.
2. Install the edger blade, clamping washer and blade
bolt.
Note: The blade bolt has left-hand threads.
3. Align the hole in the boss adapter with the hole in
the gearcase.
4. Insert the 3 mm hex wrench into the holes in the
boss adapter and gearcase to lock the attaching
shaft.
Collar
Gearcase
Boss Adapter
Edger Blade