Idiomas disponibles
Idiomas disponibles
g. Do not use a battery pack or tool
that is damaged or modified. Dam-
aged or modified batteries may exhibit
unpredictable behavior resulting in fire,
EXPLOSION or risk of injury.
h. Do not expose a battery pack or tool to
fire or excessive temperature. Expo-
sure to fire or temperature above 265°F
(130°C) may cause explosion.
i. Follow all charging instructions and do
not charge the battery pack or tool out-
side the temperature range specified
in the instructions. Charging improperly
or at temperatures outside the specified
range may damage the BATTERY and
increase the risk of fire.
j. Disconnect the battery pack from the
tool before making any adjustments,
changing accessories, or storing the
tool. Such preventive safety measures
reduce the risk of starting the tool ac-
cidentally.
k. Do not modify or attempt to repair
the tool or the battery pack except as
indicated in the instructions for use
and care.
3. Electrical safety
To reduce this risk, always follow all instruc-
tions and warnings on the battery label and
package.
Safety Rules for Thermal Imaging Cameras
Protect the measuring tool, particularly
the area around the infrared lens, speak-
er and microphone, from moisture, snow,
dust and dirt. The reception lens could fog
up or become contaminated and distort the
measurements. Incorrect settings on the
tool and other atmospheric influences may
make the measurements inaccurate.
Object temperatures could be shown to be
hotter or colder than they are, which may
present a danger if touched.
High temperature differences in a thermal
image may cause even high temperatures
General Safety Rules
Batteries can explode or
leak, cause injury or fire.
SAVE THESE INSTRUCTIONS
a. DO NOT expose the tool and battery to
rain or wet conditions. Water entering
tool will increase the risk of fire and
personal injury.
DO NOT short any battery terminals.
DO NOT mix battery chemistries.
Dispose of or recycle batteries per local
code.
DO NOT dispose of batteries in fire.
Keep batteries out of reach of children.
Remove batteries if the device will not
be used for several months.
b. Remove the batteries from the tool
when not using it for extended periods.
When storing for extended periods, the
batteries can corrode and self-discharge.
c. The tool is equipped with a radio
interface. Local operating restrictions,
e.g. in airplanes or hospitals, are to be
observed.
d. Prevent unintentional starting. Ensure
the switch is in the off-position before
inserting batteries. Accidental energiz-
ing tool that have the switch on invites
accidents.
to be shown in a color associated with low
temperatures. Coming into contact with
such an area may cause burns.
Temperature measurements will only be
correct if the emissivity setting matches
the emissivity of the object. Otherwise,
object temperatures could be shown to be
hotter or colder than they are, which may
present a danger if touched.
Do not point the measuring tool directly at
the sun or at high-performance CO₂ lasers.
This may damage the detector.
-4-
