Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Full
Check C rankcase OilLevel
Figure 14
il Drafn P lu
Fi ure1
ADJUST
SKID HEIGHT
WARNING:
Always
turn unit off, remove
ignition
key,
and disconnect
the spark
plug wire before
making
any
repairs
or adjustments.
This snowthrower is equipped with two height adjust skids, secured
to the outside of the auger housing. These elevate the front of the
snowthrower.
When removing snow from a hard surface area such as a paved
driveway or walk, adjust the skids up to bring the front of the
snowthrower down.
When removing snow from rock or uneven construction, raise the
front of the snowthrower by moving the skids down. This will help
to prevent rocks and other debris from being picked up and thrown
by the augers.
To adjust skids,
proceed
as follows:
1. Place a block (equal to height from ground desired) under
scraper bar near but not under skid.
2. Loosen skid mounting nuts (A, Figure 16) and push the skid
down (B) until it touches the ground. Retighten mounting nuts.
3. Set skid on other side at same height.
NOTE: Make sure that snowthrower
is set at same height on
both sides.
WARNING:
Be certain
to maintain
proper
ground
clearance
for your
particular
area to be cleared.
Objects
such as gravel,
rocks, or other
debris,
if
struck
by the impeller,
may be thrown
with
sufficient
force
to cause
personal
injury, property
damage,
or
damage
to the snowthrower,
Adjusting Skid Height
Figure 16
20
Tabla de contenido
