Worx H3 WX390 Manual Original página 13

Removing Bits from Chuck
On/Off Switch
Switch Lock
NOTE: The Switch Trigger Can Be
Locked In The Off Position.
Forward Rotation Control
Reverse Rotation Control
LED Light
Temperature Dependent
Overload Protection
Protection Against Deep
Discharging
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes over heated, set the
speed to maximum and run no load for 2-3 minutes
to cool the motor. SDS-plus tungsten carbide drill bits
should always be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good
condition. Where possible use a pilot hole before
drilling a large diameter hole.
5. PROBLEM SOLUTION
1. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, having not used a battery
pack for a prolonged time will reduce the battery
pack working time. This can be corrected after
several charge and discharge operations by charging
& working with your tool. Heavy working conditions
such as large screws into hard wood will use up
the battery pack energy faster than lighter working
conditions. Do not re-charge your battery pack below
0 C and above 30 C as this will affect performance.
o o
6. MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance, except for the cleaning & lubrication of
the SDS bits and adaptors before inserting into the
chuck. There are no user serviceable parts in your
power tool. Never use water or chemical cleaners to
clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep
the motor ventilation slots clean. Keep all working
controls free of dust. Occasionally you may see
Cordless Rotary Hammer
sparks through the ventilation slots. This is normal
See Fig. D4
and will not damage your power tool.
See Fig. E
7. ENVIRONMENTAL
PROTECTION
See Fig. F
See Fig. G
See Fig. H
See Fig. I
advice.
/ FOR BATTERY TOOLS
The ambient temperature range for the use and
storage of tool and battery is 0
/
The recommended ambient temperature range for
the charging system during charging is 0
8. DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Postfach 32 02 16, 50796 Cologne, Germany
Declare that the product,
Description Worx Cordless Rotary Hammer
Type WX390 WX390.X (3- designation of
machinery, representative of Hammer Drill)
Function Hammering various materials
Complies with the following directives,
2006/42/EC,2011/65/EU&(EU)2015/863,
2014/30/EU
Standards conform to
EN IEC 55014-1, EN IEC 55014-2, EN 62841-1, EN
IEC 62841-2-6
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
Postfach 32 02 16, 50796 Cologne, Germany
2023/02/06
Allen Ding
Deputy Chief Engineer,Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authorities or retailer for recycling
C-45 C.
o o
C-40 C.
o o
EN
13