cecotec BOLERO DRESSCODE 8300 INVERTER MAX A Manual De Instrucciones página 37

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1.
1. Top cover
2. Control panel
3. Power cable
4. Juice collector
5. Service filter
6. Drain hose
7. Door
8. Detergent tank
9. Water supply hose
Accessories
Fig. 2.
1. Transport screw hole plug (x4)
2. Cold water supply hose
3. Instruction manual
4. Acoustic sponges
Note:
The graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
Unpack the appliance and keep the original packaging and materials in a safe place. It
-
will help prevent any damage if the appliance needs to be transported in the future. In
case the original packaging is disposed of, make sure all packaging materials are recycled
accordingly.
Make sure all parts and accessories are present and in good conditions. If there is any
-
piece missing or not in good condition, immediately contact the Technical Support Service
of Cecotec.
- Keep all packaging materials away from children.
Note
- Before using the wash machine, the product shall be calibrated.
- Before washing the clothes for the first time, the product shall be operated in one round of
the whole procedures without the clothes inside.
72
Bolero DressCode 8300_9300 Inverter Max A
- Make sure that all pockets are empty. Sharp and rigid items such as coins, brooches, nails,
screws or stones may cause serious damage to this machine.
3. PRODUCT INSTALLATION
1. Place the device on a flat, stable and dry surface. Make sure the product does not stand on
the power cord. Fig. 3
2. Avoid exposure to direct sunlight and heat sources. Ensure good ventilation.
3. Remove the cardboard box and Styrofoam packing.
4. Lift the washing machine and remove the base packing. Make sure the small triangle foam
is removed with the bottom one together. If not, lay the unit down with on the side surface,
then remove the small foam from the unit bottom manually. Fig. 4
5. Remove the tape securing the power supply cord and drain hose.
6. Remove the water supply hose from the drum.
Removing the transport bolts
The transport bolts must be removed from the backside of the device before using it.
-
- The transport bolts will be necessary again when moving the product, so make sure they
are kept in a safe place.
- This appliance is heavy. Transport it with care. Do not hold any protruding parts when
lifting. Do not use the door to lift the appliance.
In order to remove the bolts
Fig. 5
1. Loosen the 4 bolts with a spanner and then remove them.
2. Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
Levelling the washing machine. Fig. 6
Warning
The lock nuts on all four feet must be screwed tightly against the housing.
1. Check if the legs are closely attached to the cabinet. If not, please turn them to their original
position and tighten the nuts.
2. Loosen the lock nut to turn the feet until they are in contact with the floor.
3. Adjust the feet and tighten the washers with a spanner. Make sure the machine is steady.
Water supply hose connection
Warning
- Do not kink, crush, modify or repair the water supply hose.
Make the connection manually, do not use tools. Check the connection is optimal.
-
ENGLISH
73
Bolero DressCode 8300_9300 Inverter Max A