Makita DUC256 Manual De Instrucciones página 20

— The file can be guided more easily if a file holder
(optional accessory) is employed. The file holder has
markings for the correct sharpening angle of 30° (align
the markings parallel to the saw chain) and limits the
depth of penetration (to 4/5 of the file diameter).
30
Fig.28
► 1. File holder
— After sharpening the chain, check the height
of the depth gauge using the chain gauge
tool (optional accessory).
Fig.29
— Remove any projecting material, however small,
with a special flat file (optional accessory).
— Round off the front of the depth gauge again.
Cleaning the guide bar
Chips and sawdust will build up in the guide bar
groove. They may clog the bar groove and impair
the oil flow. Clean out the chips and sawdust every
time when you sharpen or replace the saw chain.
Fig.30
1
1/5
Cleaning the sprocket cover
Chips and saw dust will accumulate inside of the
sprocket cover. Remove the sprocket cover and
saw chain from the tool then clean the chips and
saw dust.
Fig.31
Cleaning the oil discharge hole
Small dust or particles may be built up in the oil
discharge hole during operation. These dust or
particles may impair the oil to flow and cause an
insufficient lubrication on the whole saw chain.
When a poor chain oil delivery occurs at the
top of guide bar, clean the oil discharge hole as
follows.
1. Remove the sprocket cover and saw chain
from the tool.
2. Remove the small dust or particles using a
slotted screwdriver or the like.
Fig.32
► 1. Slotted screwdriver 2. Oil discharge hole
3.
Insert the battery cartridge into the tool. Pull
the switch trigger to flow built-up dust or particles
off the oil discharge hole by discharging chain
oil.
4.
Remove the battery cartridge from the tool.
Reinstall the sprocket cover and saw chain on
the tool.
20 ENGLISH
2
1