Wilo -Atmos BST Instrucciones De Instalación Y Funcionamiento página 34

en
2.4 Transport
2.5 Installing/dismantling
34
• Before commencing work, disconnect the product from the
mains and secure it against being switched on again.
• Give staff training on how to establish the electrical connection
and the methods for switching off the product.
• Protect the electrical connection with a residual-current device
(RCD).
• Observe the technical information in these installation and op-
erating instructions as well as on the rating plate.
• Earth the product.
• Comply with the manufacturer's specifications when connect-
ing the product to electrical switching systems.
• Have a defective connection cable replaced immediately by a
qualified electrician.
• Never remove operating elements.
• Comply with the specifications on electromagnetic compatibil-
ity when using electronic start-up controllers (e.g. soft starter
or frequency converter). If required, consider special measures
(shielded cables, filters, etc.).
• Wear protective equipment:
Safety gloves for protection against cuts
–
Safety shoes
–
Sealed safety glasses
–
Safety helmet (when using lifting equipment)
–
• Only use legally specified and approved lifting slings.
• Select the lifting sling based on the prevailing conditions
(weather, slinging point, load etc.).
• Always attach the lifting sling to the designated slinging points
(lifting eyes).
• Position the lifting accessory in a way that ensures stability
during use.
• When using lifting equipment, a second person must be
present to coordinate the procedure if required (e.g. if the op-
erator's field of vision is blocked).
• Persons must not stand underneath suspended loads. Do not
move suspended loads over workplaces where people are
present.
• Wear protective equipment:
Safety shoes
–
Safety gloves for protection against cuts
–
Safety helmet (when using lifting equipment)
–
• Locally applicable laws and regulations on work safety and ac-
cident prevention must be complied with.
Installation and operating instructions • Wilo-Atmos BST • Ed.01/2023-07