Chamberlain LiftMaster PROFESSIONAL ART300 Serie Instalación Mecánica página 65

All manuals and user guides at all-guides.com
IMPORTANT FITTING AND OPERATING INSTRUCTIONS
PLEASE START BY READING THESE IMPORTANT SAFETY RULES
This safety alert symbol means „Caution" - failure to comply with such an instruction involves risk of personal
injury or damage to property. Please read these warnings carefully.
This gate drive mechanism is designed and tested to offer appropriately safe service provided it is installed and
operated in strict accordance with the following safety rules.
Incorrect installation and/or failure to comply with the following instructions may result in serious personal
injury or property damage.
When using tools and small parts to install or
carry out repair work on a gate exercise caution
and do not wear rings, watches or loose
clothing.
Installation and wiring must be in compliance
with your local building and electrical
installation codes. Power cables must only be
connected to a properly earthed supply.
Entrapment protection devices MUST be
installed to protect anyone who may come
near a moving gate. Locate entrapment
protection devices to protect in BOTH the
open and close gate cycles. Locate
entrapment protection devices to protect
between moving gate and RIGID objects,
such as posts.
Please remove any locks fi tted to the gate in
order to prevent damage to the gate.
After the installation a fi nal test of the full
function of the system and the full function of
the safety devices must be done.
This drive cannot be used with a gate
incorporating a wicket door unless the drive
cannot be operated with the wicket door open.
Gate must not extend over public byway during
operation.
Lightweight gates must be substantially
reinforced to avoid gate damage. The best
solution is to check with your gate manufacturer
for an opener installation reinforcement kit.
Activate opener only when the gate is in full
view, free of obstructions.
Do not allow children to play near the gate.
Humidity and water destroy the control board.
Make sure under all circumstances that water,
humidity or dammed-up water cannot penetrate
the control board covering.
WARNING / ATTENTION
Frequently examine the installation for imba-
lance and signs of wear or damage to cables,
hardware and mountings. Do not use if repair or
adjustment is necessary. Gates which stick or
jam must be repaired immediately. Employ a
qualifi ed technician to repair the gate, never
attempt to repair it yourself.
Keep additional accessories away from children.
Do not allow children to play with pushbuttons
or remote controls. A gate can cause serious
injuries as it closes.
Disconnect electric power to the system before
making repairs or removing covers.
A disconnecting device must be provided in the
permanently-wired installation to guarantee
allpole disconnection by means of a switch
(at least 3mm contact gap) or by a separate fuse.
Make sure that people who install, maintain or
operate the gate drive and/or the control board
are qualifi ed and follow these instructions.
Keep these instructions in a safe place so that
you can refer to them quickly when you need to.
The full protection against potential squeeze or
entrapment must work direct when the drive
arms are installed.
This appliance is not intended for use by
persons (including children) with reduced
physical sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
Automatic drive – Keep away from the area of
the gate since it may operate unexpectedly.
SAVE THESE INSTRUCTIONS
1/16 en