Idiomas disponibles
Idiomas disponibles
Chapter 2:
the CD
Player
Playing a CD (normal play)
Playing Tracks in Random
Order (shuffle play)
Playing Tracks in the
Desired Order
(programme play)
Playing Tracks Repeatedly
(repeat play)
Playing a CD
(normal play)
You can play CDs in four modes: normal,
shuffle, programme and repeat. The mode
determines which tracks (songs) to play, in
which order and whether or not they will
repeat.
Also, you can play 12 cm and 8 cm CDs.
When you play an 8-cm CD, place it
without an adaptor on the inner circle of
the disc tray.
Before you play the CD, decrease the sound
level by pressing VOL –. This will prevent
damage to the speakers.
Tuner CD player
1
1
Press POWER.
2
Press 6 (open/close) and place a CD on
the CD tray.
with the label side up
3
Press ^ (play) (or ( on the remote).
The disc tray closes and the first track
starts playing.
1
0 0 3
4
Press VOL + or – to adjust the sound
level.
To
Press
p
Stop play
^ (or P*)
Pause
To resume play, press
here again.
6
Remove the CD
* Remote
One Touch Play feature
Press ^ (or ( on the remote) when the
power is off or you are listening to another
source.
As long as a CD is in the player, you will be
able to listen to the CD without pressing any
other buttons.
To find the beginning of a track –
Automatic Music Sensor (AMS)
You can locate the beginning of a track
while the track is playing or while it is in
pause mode.
To locate the beginning of the current or
preceding track, press =0 (or = on
the remote) until you find the desired track.
To locate the beginning of the succeeding
track, press )+ (or + on the remote)
until you find the desired track.
To find a point in a track
You can find a particular point in a track
while playing or pausing a CD. Use the
buttons on the player to operate this
p
feature. This operation is not possible with
2
the remote.
3
To Search
Operation
Hold down )+
Forward while
4
listening
and release it at the
desired point.
Hold down =0
Backwards
while listening
and release it at the
desired point.
Hold down )+ or
Quickly
=0 during pause
without
listening while
and release it at the
checking the
disired point.
playing time in
the display
Note
If the CD reaches the end while you are
searching quickly without listening,
"OVER"appears in the display. Press =0
(= on the remote) to go back.
To check the total number of tracks
and total playing time
Press DISPLAY on the remote while the
player is in stop mode.
The indications appear for a few seconds.
Total number of tracks
Total playing time
To check the remaining time
Press DISPLAY on the remote repeatedly
while playing a CD.
Each time you press DISPLAY, the display
changes as follows.
Current track number and
playing time
v
Current track number and
remaining time on the track
v
Remaining time on the CD
Chapter 2: the CD Player
EN
7
1 2
5
4
0 5
Z
