Idiomas disponibles
Idiomas disponibles
Assembly
ASSEMBLING THE CITRUS PRESS
1. Wash the Juicing Cone, Juice Collector,
Juice Filter and Fruit Dome with
warm soapy water before first use.
2. Pull the juice press arm up, away from
the motor base, until fully extended.
3. Place the juice collector onto the drive
shaft on top of the motor base, ensuring
the juice spout fits into the semi-circular
groove at the front of the motor base.
4. Insert the filter into the juice collector,
aligning the indent with arrow in the
bottom of the filter over the corresponding
tab with arrow in the juice collector.
5. Place the juicing cone onto the
drive shaft and press down lightly
to lock the cone into position.
6. To insert the fruit dome, place it into
the hole on the underside of the
juice press arm. The fruit dome is
magnetic and will stick into place.
7. Ensure the anti-drip juice spout is pushed
down into the pouring position.
DISASSEMBLING THE CITRUS PRESS
1. Turn the citrus press OFF at the ON/OFF
switch, then unplug from the power outlet.
2. Pull the juice press arm up, away from
the motor base, until fully extended.
Close the anti drip spout by flipping it up.
3. Remove the fruit dome by pulling on
it gently to release the magnet
4. Lift the juice collector from the base with
the filter, juicing cone and fruit dome
still in place. Remove the cone and filter
from the juice collector over a sink for
easier cleaning. Follow recommended
care and cleaning guidelines.
Functions
1. Ensure the citrus press is correctly
assembled and a container is placed
under the juice spout before juicing.
2. Cut the citrus fruit in half by cutting across
the fruit segments, rather than across the
tip ends, to ensure more efficient juicing.
NOTE
Some fruits, such as lemons and tangelos,
have knobbly tip ends which require trimming
for better contact with the fruit dome.
3. Plug the power cord into a 110/120V power
outlet, then press ON/OFF switch to ON.
4. Place a citrus fruit half, cut side
down, onto the juice cone and push
down lightly onto the spikes.
5. Grasp the handle and slowly lower the
juice press arm. Press down (in a gentle
but firm action) until the fruit dome is
in contact with the fruit skin. The motor
will automatically start and the juicing
cone will begin to rotate. The juice will be
extracted from the fruit and flow through
the juice spout into the glass. The pulp
and seeds will collect in the filter.
6. The citrus press juices very quickly so each
fruit half will be juiced in a few seconds. To
automatically stop the motor, lift the juice
press arm up to its extended position.
7. Remove the used fruit from the juicing
cone. Empty excess pulp and seeds
from the filter as required. Repeat
Steps 3–7 to continue juicing.
EN
7
