Tabla de contenido
Idiomas disponibles
Idiomas disponibles
General features
Audio Setup
Setting the Sound system, such as Cross over
Network.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item
Display
2
Front High Pass Filter*
"HPF"
Rear High Pass Filter*
2
"HPR"
1,2
Low Pass Filter*
"LPF"
Subwoofer Phase*
1,2,3
"PHAS"
Volume offset
"V-OFF"
Loudness
"LOUD"
• Volume offset: Sets each source's volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
• *
1
You can control this item when <Subwoofer
Output> (page 11) is set to "SW ON".
• *
2
Function of the KDC-MP4032.
• *
3
You can control this item when Low Pass Filter is not
set to Through.
5
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
10
|
English
Range
Through/80/100/120/150/
180 Hz
Through/80/100/120/150/
180 Hz
60/80/120/Through Hz
Reverse (180°) / Normal (0°)
–8 — ±0
OFF/ON
Speaker Setting
Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Speaker Setting mode
Press the [VOL] knob.
3
Select the Speaker type
Turn the [VOL] knob.
Each time you turn the knob, the setting
alternates between the settings shown in the
table below.
Speaker type
Display
OFF
"SP OFF"
For 5 & 4 in. speaker
"SP 5/4"
For 6 & 6x9 in. speaker
"SP 6*9/6"
For the OEM speaker
"SP OEM"
4
Exit Speaker Setting mode
Press the [VOL] knob.
Capítulos
Tabla de contenido
