Idiomas disponibles
Idiomas disponibles
Using Vehicle Lap/Shoulder Belt
(preferred installation method)
1
- Route vehicle lap/shoulder belt through
rear facing belt path and buckle vehicle lap/
shoulder belt. Vehicle belt must be routed
under True Tension door. (1)
Remove all slack from the vehicle belt system to
properly secure this child restraint. (2) Lock
vehicle belt (refer to vehicle owner's manual).
2
Close True Tension door and replace seat cover
and infant insert (if used).
Test by pulling on shoulder belt to ensure it is
locked.
To open True Tension door, unbuckle vehicle belt
and push down slightly on door to release tension.
WARNING: Check that child restraint is
securely installed before each use.
Check Installation
Seat is in appropriate rear facing recline position.
Seat is securely installed. Hold seat near rear-
facing belt path and move seat side to side, front
to back, and up and down. Seat should move
less than 1 inch.
Tether strap is not used for rear facing
installation and must be secured in storage
location on back of child restraint.
Cup holders may be placed in any position after
installation.
44 RAVA instructions
1
BLUE
2
2
1
RAVA instructions
45
