Idiomas disponibles
Idiomas disponibles
Using Lower Anchor Belt
WARNING: Do not install by this method for
a child weighing more than 35 lb (15.8 kg).
1
- Remove lower anchor belt from storage
compartment (p.28) and route through
rear facing belt path under cup holder.
2
- Lengthen lower anchor belt as necessary (p.28)
and attach to lower anchor points in vehicle.
3
- Remove all slack from lower anchor belt by
pulling loop at end of belt.
4
- Close True Tension door and replace seat cover
and infant insert (if used). Pull crotch belt
through slot.
To open True Tension door, unbuckle vehicle belt
and push down slightly on door to release tension.
WARNING: Check that child restraint is
securely installed before each use.
Check Installation
Seat is in appropriate rear facing recline
position.
Seat is securely installed. Hold seat near rear-
facing belt path and move seat side to side, front
to back, and up and down. Seat should move
less than 1 inch.
Tether strap is not used for rear facing
installation and must be secured in storage
location on back of child restraint.
Cup holders may be placed in any position after
installation.
46 RAVA instructions
1
BLUE
2
3
4
RAVA instructions
47
