Initial Use; Installation Location; Filling The Water Tank - Beurer LB44 Instrucciones De Uso

Principle behind the LB44 air humidifier
[1] A membrane, vibrated by ultrasound,
moves the water and releases tiny water
droplets from the surface.
[2] The fan draws in air at the bottom of the
device.
[3] The air is humidified with the released
water droplets and blown gently upwards
towards the opening.

5. Initial use

Unpacking the device
Warning!
Keep packaging material away from children!
There is a choking hazard.
> Open the cardboard packaging
> Remove the protective insert
Keep the plastic film closed.
> Lift the device up and out of the packaging
> Remove the plastic covering
> Check the device, the mains plug and the
cable for damage

Installation location

Warning!
Before putting the device into operation, read
the safety notes in the Safety chapter.
w Safety pages 10 and 11
Important!
• The immediate vicinity of the air humidifier
can become damp.
• Calcareous water can leave white
deposits.
• Do not place the device on the floor, but in
a raised position (e.g. on a table or chest
of drawers).
• Position the device so that the mist outlet
is not directed towards objects.
• Empty any remaining water when the
device is not in use.
> Place the air humidifier on a firm, level and
water-resistant surface
If the device should accidentally tip over,
water may escape, even if the device is
switched off and unplugged.
2
Water
Important!
• Do not add any essential oils or fragrances
to the water. If additives are used, the
plastic material may become discoloured
and damaged. The ultrasound membrane
gets stuck and is damaged.
• Use fresh drinking water in the device.
If the drinking water is very hard, you can
use demineralised or distilled water.
Tip!
If the water is hard, we recommend using the
optional anti-limescale filter.
w 8. Spare parts

Filling the water tank

> Lift the water tank using the recessed grip
and rotate it
The water tank is kept closed by means of
a spring valve.
> Open the screwed plug on the water tank
> Fill with water
The water tank holds a maximum of 2.8 litres.
The water level can be seen from the outside.
> Tightly close the water tank using the
screwed plug
> Rotate the water tank, holding the
recessed grip, and place it on the base
unit
The tank should sit tightly on the base unit.
13
3
1