Medisana 51152 Instrucciones De Manejo página 25

Ocultar thumbs Ver también para 51152:
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 55
3.3 Setting the date and time
1. With the unit switched off, simultaneously press the START button
M button
to set the date and time. First of all the entry point for the month
flashes (1, 2, 3... 12).
2. Press the M button
appears.
3. Press the START button
the date flashes.
4. Proceed in exactly the same manner as described in point 2 when entering the
date, hours and minutes.
5. In each case, press the M button
the entry.
6. The date and time are displayed continuously. If the batteries are changed the
information is lost and the date and time must be set again.
3.4 Setting up the user memory
The MTS gives you the opportunity to assign readings to one of two user memo-
ries, each of which provides 60 memory slots.
Press the Start button
the display
. Press the M button
user/memory 2 U2.
4 Operation
4.1 Fitting the cuff
First attach the free end of the cuff's air tube
the unit.
Open up the cuff to a ring and slip it over the bare left upper arm just above the
elbow region. If wearing tight clothing, ensure that the circulation in the arm is not
impaired when rolling up the sleeve. Please ensure that the cuff buckle is never
positioned directly over the artery, as this can result in an incorrect blood pressure
reading.
The tube should run along the centre of the inner arm towards the palm of the
hand. Ensure that the cuff itself is not twisted in any way. Fasten the pressure cuff
in such a way that it fits tightly but does not constrict the arm. Do this by passing
the end through the buckle, pulling it tight and attaching it to the Velcro fastener.
Only position the cuff on the right arm if it cannot be used on the left arm. Always
carry out measurements on the same arm.
3 Getting Started / 4 Operation
repeatedly until the desired number for the month
again to accept the setting. Now the entry point for
to select and the START button
until the symbol for the U1 (USER) memory appears in
to choose between user/memory 1 U1 and
to the designated connector
GB
and the
to accept
on
19
loading

Este manual también es adecuado para:

Mts