Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1
1. Outer flange
2. Wrench
NOTE: To hold the outer flange, insert the wrench
into the opening between the diamond wheel and the
guide rule.
To install the wheel, follow the removal procedure in
reverse. When placing the diamond wheel, insert it from
the opening between the tool and the guide rule. Always
install the wheel so that the arrow on the diamond
wheel points in the same direction as the arrow on the
blade case.
1. Inner flange
2. Diamond wheel
4. Hex bolt
Installing water hose
Remove the coupling sleeve from the tool and attach
the water hose. Connect the coupling sleeve to the
water hose and attach it again to the tool.
2
1. Coupling sleeve
2. Nut
3
2
3. Hex wrench
4
3
2
1
3. Outer flange
1
7 ENGLISH
1.
Remove the coupling sleeve from the tool by
pulling the lower half of the sleeve.
2.
Remove the nut on the coupling sleeve.
3.
Pass the water hose through the nut.
4.
Insert the tip of the hose into the sleeve so that the
inner fringes hold it.
5.
Fully tighten the nut and attach the coupling
sleeve to the tool.
Water supply adjustment
Turn the water cock counterclockwise to supply
water. Adjust the amount of water by turning the cock
gradually.
1. Water cock
OPERATION
CAUTION:
THIS TOOL SHOULD ONLY BE
USED ON HORIZONTAL SURFACES.
CAUTION:
Be sure to move the tool forward
in a straight line and gently. Forcing and exerting
excessive pressure or allowing the wheel to bend,
pinch or twist in the cut can cause overheating of the
motor and dangerous kickback of the tool.
CAUTION:
When operating, always hold the
insulated grips. Do not hold the guard.
1
Tabla de contenido
