Idiomas disponibles
Idiomas disponibles
10
1. Read again this manual and make sure there is no problem due to a weak
accumulator in the receiver or transmitter and if needed charge them.
2. If the accumulator is discharged qiuckly - accumulator life is near its end, replace it
with a new one.
3. If the accumulator in the transmitter is discharged quickly adjust the position
interval update to a lower level.
4. Check if the fault is caused by improper use.
5. Check the GPS signal of the receiver and transmitter in the open space.
6. If the transmitter and receiver are not communicating, try to pair those devices
again - see Chapter: 7.4 Pairing of transmitter and receiver on pg. 11.
7. In case of an inaccurate direction indication of the dog from you, re-calibrate
correctly compass - see chapter: 7.5 Calibrating the digital compass on pg. 12.
8. If the product does not indicate the exact position, calibrate the compass, locate
the best GPS signal and make sure that the RF and GPS antenna on both devices
are pointing to the sky.
9. If the problem persists, contact your dealer.
11
To clean your device DOG GPS X20 never use volatile substances, such as.: thinner,
gasoline or other cleaners. Use a soft, damp cloth and neutral cleaner.
If the device is not in use for longer period of time, charge the accumulator at least
once a year.
After any replacement of battery in the transmitter (unscrewing the plastic cap on
the transmitter cabinet) it is necessary to regularly check tightening of the screws of
the transmitter cabinet. Tighten the screws with adequate force.
WARNING: If moisture ingress occurs in the transmitter cabinet due to improper
tightening of the screws of the transmitter cabinet, warranty will be void.
If you use the GPS X20 transmitter in extreme terrain where excessive mechanical
wear occurs, it is necessary to protect the transmitter. In case of excessive wear, the
warranty repair will not be accepted.
TROUBLESHOOTING
DEVICE MAINTANANCE
19
