Idiomas disponibles
Idiomas disponibles
exposure of the collar on the dog's skin may cause skin irritation. If it happens, do not
use DOG GPS until all traces of irritation are gone.
7
RECEIVER PREPARATION (HANDHELD DEVICE)
7.1 Receiver charging
Receiver contains Li-Pol accumulator. Before first use,
the accumulator must be recharged.
1. Before charging clean the receiver charging
contacts from any dirt. Connect the charging clip
to the receiver (see the picture).
2. Connect supply cable to the power adapter and
plug it into the mains.
3. Lines in battery symbol start to show gradually on
LCD.
4. Charging time is approximatelly 3 hours.
5. Accumulator is charged, when the battery symbol is full – see below.
WARNING: Optimal temperature for charging is from 0 °C up to 40 °C. Use
only the original power adapter supplied in the packing with the device. Other
chargers could damage the accumulator.
7.2 Receiver accumulator status
check
The accumulator status of the receiver is
indicated on the battery symbol in the
Information panel of the receiver - upper
display line.
7.3 Receiver setting
Switching receiver ON/OFF – hold the button
To choose the dog, press
To switch ON/OFF the LCD backlight, press shortly
15 minutes, after that it will switch itself off automatically.
7.4 Pairing – coding of transmitter (collar) with receiver (handheld
device)
1. Switch ON the receiver and transmitter, which you need to pair together – switch
OFF other transmitters.
2. Hold the button CODE on the receiver for 2 seconds.
3. By arrows
/
(collar). Free position (where there is no paired transmitter) indicates lettering
on the LCD.
4. Hold the button CODE again for 2 seconds.
/
.
choose the position, to which you want to pair the transmitter
status charge
100%
70%
40%
10%
for 2 seconds.
backlight will shine for
receiver
11
