Idiomas disponibles
Idiomas disponibles
Protective measures against
kickbacks
In the event of a kickback, the
operator will feel a powerful
blow from the petrol-powered
trimmer. This may lead to lo-
sing control of the device and
serious injury. You can avoid
kickbacks through caution
and proper technique.
While working with the 3- or 4-tooth bla-
de there is a risk of kickback if the blade
edge hits an obstacle (stone, wood).
• Hold the device with both hands.
• Make sure there are no obstacles on the
ground and do not use the 3- or 4-tooth
blade near fences, metal posts or similar.
Assembly
Installing the protective
cover
Never use the device without
the protective cover correctly
installed! Risk of injury.
1. Position the protective cover (13) on the
shaft holder (34).
2. Turn the screw (33) in the protective
cover (13) using the (smaller) 4-mm Al-
len key (24).
Use only properly
sharpened tools. To
cut thick stems, switch
the device to position
A.
Fitting the Two-Part
Tube
1. Loosen the tube fixing screw (35) on
the top shaft tube (8).
2. Push the lower shaft tube (12) as far as
possible into the upper shaft tube (8).
3. Push the lock (11) and slide the lower
shaft tube (12) as far as it goes into the
upper shaft tube (8).
4. Turn the lower shaft tube (12) with a
gentle rotating movement until the lock
(11) clicks into place in the bore on the
upper shaft tube (8).
5. Retighten the tube fixing screws (35) by
hand.
Ensure that the bottom shaft tube is
sitting firmly and safely before start-
ing the equipment.
Dismantling:
1. Loosen the tube's mounting screw (35).
2. Push the lock (11).
3. Pull the shaft tubes apart.
Mounting the multi-
functional handlebar
1. Loosen the star screw (36) and remove
the handle mount (37) from the upper
shaft tube (8).
2. Insert the multifunction handle (10) into
the holder (38) on the upper shaft tube
(8). The plastic ring on the multifunction
handle must sit in the guide rail of the
holder (38).
3. Fasten the multifunction handle to the
handle mount (37) and star screw (36).
Tighten the star screw (36) by hand.
Check and make sure that the de-
vice cable (
by the cable holder (
GB
A
18) is held in position
A
19).
MT
41
