Switching Bike Lights On/Off; Switching The Push Assistance On/Off; Displays And Settings Of The On-Board Computer; Speed And Distance Indicators - Bosch Intuvia Instrucciones De Servicio

change to a higher gear with lower cadence. If indica-
tor (h) is displayed, you should select a lower gear
with higher cadence.

Switching bike lights on/off

On the model in which the lighting is powered by the
eBike system, the front and rear lights can be
switched on and off at the same time via the on-board
computer using the bike light button (2).
Before starting each journey, check that your bike
lights are working correctly.
When the lighting is switched on, <Lights on> ap-
pears and when the lighting is switched off, <Lights
off> appears for approx. 1 s on the text indicator (d).
The lighting symbol (c) is displayed when the light is
on.
The on-board computer saves the light status and ac-
tivates this saved status accordingly after a restart.
Switching the bike lights on and off has no effect on
the backlighting of the display.

Switching the push assistance on/off

The push assistance aids you when pushing your
eBike. The speed of this function depends on the se-

Displays and settings of the on-board computer

Speed and distance indicators

The speedometer (f) always displays the current
speed.
You can choose from the following functions in the
function display (combination of text indicator (d)
and value indicator (e)):
– <Clock>: Current time
– <Max. speed>: Maximum speed achieved since
the last reset
– <Avg. speed>: Average speed achieved since the
last reset
– <Trip time>: Journey time since the last reset
– <Range>: Estimated range of the available battery
charge (at constant conditions such as assistance
level, route profile, etc.)
Bosch eBike Systems
lected gear and can reach a maximum of 3.7 mph.
The lower the selected gear, the lower the speed of
the push assistance function (at full power).
The push assistance function must only be used
u
when pushing the eBike. There is a risk of injury if
the wheels of the eBike are not in contact with the
ground while using the push assistance.
To activate the push assistance, briefly press the
WALK button on your on-board computer. After acti-
vation, press the + button within 3 s and keep it
pressed. The eBike drive is switched on.
Note: The push assistance cannot be activated at as-
sistance level OFF.
The push assistance is switched off as soon as one of
the following occurs:
– You release the + button;
– the wheels of the eBike are locked (e.g. by applying
the brakes or hitting an obstacle);
– the speed exceeds 3.7 mph.
The push assistance function is subject to local regu-
lations; the way it works may therefore differ from the
description above. It can also be deactivated.
– <Odometer>: Total distance traveled with the
eBike (cannot be reset)
– <Trip distance>: Distance traveled since the last
reset
To switch between display functions, press
the i button (1) on the on-board computer or
the i button (10) on the operating unit repeatedly un-
til the required function is displayed.
To reset the <Trip distance>, <Trip time> and
<Avg. speed>, switch to one of these three functions
and then press and hold the RESET button (6) until
the indicator is set to zero. This will also reset the val-
ues of the other two functions.
English – 11
1 270 U20 XBI | (07.04.2020)