Transporting The Saw - Genesis GMSUDR15L Manual Del Operario

changes in the laser's path. With patience and practice you'll be able to place the laser line in the ideal position for your style of blade to cut line
alignment. (FIG 12)
OPErATiOn
WArning:
Always be sure the miter saw is disconnected from the power source before making any
adjustments or setting up prior to cutting. Failure to disconnect or unplug the machine may cause accidental starting,
resulting in serious personal injury.

TRANSPORTING THE SAW

1. Always make sure the saw head is down and locked.
2. Make sure the miter table is locked, Bevel is locked at 0° position.
3. Make sure the sliding saw head is in the most backwards position and locked.
4. Only lift the saw by the carrying handle or outer castings.
WArning:
Always transport the miter saw in the locked down position, carrying the saw by carrying handle
on the cutting arm. DO nOT lift or carry the miter saw using the switch handle, doing so may cause misalignment of
miter and bevel settings.
LOCKING AND UNLOCKING THE CUTTING HEAD
When storing or transporting the miter saw, the cutting head should be locked in the down position.
To lock down the cutting head,
1. Lower the cutting head completely.
2. Pull back on locking knob (24) outwards from its parked "Unlock" (b) position.
3. Rotate the locking knob a 1⁄4 turn, and then release it to "Lock" (a) position (FIG 13)
To unlock the cutting head,
1. Press down lightly on the cutting head.
2. Pull back on lock knob outwards from its "Lock" position (a).
3. Rotate the lock knob 1⁄4 turn, then release it into "unlock" position (b)
4. Slowly raise the cutting head into the work position. (FIG 13)
WArning:
Always transport the miter saw in the locked down position, carrying the saw by carrying handle on
the cutting arm. DO nOT lift or carry the miter saw using the switch handle, doing so may cause misalignment of miter
and bevel settings.
STARTING AND STOPPING THE MITER SAW
To start the miter saw, firmly grasp the saw's top handle and depress the switch trigger.
To stop the miter saw, completely release the switch trigger.
This miter saw is equipped with an automatic electric blade brake. When the switch trigger is released, the electric brake is activated and stops the saw
blade in seconds.
WArning:
After completing a cut, release the switch trigger to activate the electric blade brake. Keep the
cutting head down until the blade comes to a complete stop before raising the cutting head to the upward or starting
position. A rotating saw blade can be dangerous.
WArning:
The torque resulting from electric blade brake activation may loosen the arbor bolt. Occasionally
check the arbor bolt and tighten if necessary.
TABLE HAZARD AREA
On the stationary table, on each side of the rotating miter table, is a "hands" warning symbol that is
cast into the table. (See FIG 14) The area between the two "hand" symbols is designated as a "Hazard
Zone" and the miter saw operator should never place their hands inside this area while the miter saw
is running.
WArning:
Keep your hands outside the "Hazard Zone" and out of the path of the saw blade. Use the supplied
work clamp or other clamping means to secure the work piece in place before making a cut with the miter saw.
WArning:
Always be sure the miter saw is disconnected from the power source before making any
adjustments or during set-up prior to cutting. Failure to disconnect or unplug the machine may cause accidental
starting, resulting in serious personal injury.
a
FIG 13
24
b
FIG 14
11
11