Genesis GMSUDR15L Manual Del Operario página 4

Sierra ingleteadora compuesta deslizante
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

• Do not force the power tool.
could possible damage the tool and may result in personal injury.
• Use the correct power tool for the job.
• Do not use tool if switch does not turn it on or off.
must be repaired or replaced by an authorized service center
• Turn power tool off, and disconnect the plug
any adjustments, changing the accessories, or storing the tools
which may cause personal injury
• Store idle tool out of reach of children and other inex
users.
• Maintain power tools with care.
conditions that may affect the tool's operation. A guard or any other part that is damaged must be properly repaired or replaced by an
authorized service center to avoid risk of personal injury.
• Use recommended accessories.
use on this type tool may cause damage to the tool or result in personal injury to the user. Consult the operator's manual for recommended
accessories.
• Keep cutting tools sharp and clean.
.
easier to control
• Feed the work piece in the correct direction and speed.
against the direction of the cutting tool's direction of rotation only. Incorrectly feeding the work piece in the same direction may cause the work
piece to be thrown out at high speed.
• Never leave the tool running unattended, turn the power off.
• Never start the power tool when any rotating component is in contact with the work piece.
WArning:
USE OF THiS TOOL CAn gEnErATE AnD DiSBUrSE DUST Or OTHEr AirBOrnE PArTiCLES, inCLUDing WOOD
DUST, CrYSTALLinE SiLiCA DUST AnD ASBESTOS. Direct particles away from face and body. Always operate
tool in a well-ventilated area and provide for proper dust removal. Use dust collection system wherever possible.
Exposure to the dust may cause serious and permanent respiratory or other injury, including silicosis (a serious lung
disease), cancer, and death. Avoid breathing the dust, and avoid prolonged contact with the dust. Allowing dust to
get into your mouth or eyes, or lay on your skin may promote absorption of harmful material. Always use properly
fitting niOSH/OSHA approved respiratory protection appropriate for dust exposure, and wash exposed areas with
soap and water.
SERVICE
Have Your Power Tool Serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
• Service Your Power Tool periodically.
wires may be misplaced or pinched or safety guard return spring may be improperly installed.
WArning:
rEAD AnD UnDErSTAnD ALL WArningS, CAUTiOnS AnD OPErATing inSTrUCTiOnS BEFOrE USing THiS
EQUiPMEnT. Failure to follow all instructions listed below may result in electric shock, fire and/or serious
personal injury.
SAVE THESE INSTRUCTIONS
10" Slide Compound Laser Miter Saw
Operator's Manual
The tool will perform the job better and safer at the feed rate for which it is designed. Forcing the tool
Don't force the tool or attachment to do a job for which it is not designed.
.
from the power source and/or battery pack from the power tool before making
.
Such preventive safety measure reduce the risk of an accidental start up
.
Check for proper alignment and binding of moving parts, component breaks, and any other
Using accessories and attachments not recommended by the manufacturer or intended for
Properly maintained cutting tools with sharp cutting edges are less likely to bind and are
When cleaning a tool, be careful not to disassemble any portion of the tool since internal
Any tool that cannot be controlled with the switch is dangerous and
erienced persons.
p
It is dangerous in the hand of untrained
Feed the work piece into a blade, cutter, or abrasive surface
Do not leave the tool until it comes to a complete stop.
GMSUDR15L
Tabla de contenido
loading

Tabla de contenido