Never place the device on a flammable surface.
To ensure proper functioning, the device must have sufficient ventilation. For this
reason, it is necessary to maintain the following safe distances (see figure below):
- above the device: 30 cm
- at the rear: 7.5 cm
- at the sides: 7.5 cm
Never block the ventilation holes. Never disassemble the device's feet.
The device must maintain a minimum distance of 2m from radios, television sets,
etc. in order to avoid interference with the signal reception.
Position the devices so that the plug is easily accessible and if necessary can be
easily removed from its socket.
Connection
DANGER! Electric shock hazard!
The device can cause injuries due to improper installation!
Before installation and connecting the local power grid
specification should be compared with that of the device
(see rating plate). Connect the device only in case of
compliance!
The electrical circuit in the socket must be secured to at least 16A (automatic fuse B).
Connect the device only to the wall socket; do not use any extension cords or power
strips.
This device must be grounded. In case of short-circuit the grounding will protect
against electric shock, because the electrical current will be released through an
additional wire. The device is equipped with a power cord with the grounding wire
and a plug with a safety contact. Connect the plug to the properly installed and
grounded socket.
30 cm
7,5 cm
7,5 cm
7,5 cm
- 33 -