brondell S1200-EW Manual De Usuario página 34

TROUBLESHOOTING (cont.)
Problem
The bidet seat
is not working
Product shuts off
during use
Low water flow or
spray pressure
Nozzles do not
function properly
32
Possible Cause(s)
1. Bidet not plugged in
2. No power to Swash
3. There is power, but nothing hap-
pens when trying to use the Swash
4. The incoming water is too hot
5. Not activating Seat Sensor
1. Washing time exceeded the cycle
time
2. Power failure
3. Water supply too hot
1. Clogged filter
2. Water supply valve not opened fully
3. Nozzles dirty
4. External bidet filter
5. Pressure & wide spray settings
1. Nozzles are dirty
2. Clogged filter
3. Water pressure is too low
4. External bidet filter
Solution(s)
1. Make sure the bidet is plugged in.
2. Check and reset GFCI outlet.
3. The Remote Control batteries may be
dead. Replace them if necessary.
4. Ensure that the bidet seat is connected to
the cold water supply.
5. Adjust sitting position to fully cover the
Seat Sensor. Override the Seat Sensor (refer
to special mode operation section to unlock
Seat Sensor).
1. Press the wash button during cycle to extend
the time (see operation section for more infor-
mation about wash functions).
2. Check and reset GFCI outlet.
3. Ensure that the Swash is connected to the
cold water supply only.
1. Remove, clean, and reinstall mesh filter
(see maintenance section).
2. Check that the water supply valve at wall
is fully open.
3. Clean nozzles (see maintenance section).
4. If you have an external bidet filter, check
and replace if necessary.
5. Adjust the water pressure settings on the
remote to increase and adjust the wide spray
settings on the remote.
1. Clean nozzles (see maintenance section).
2. Remove, clean, and reinstall mesh filter
(see maintenance section).
3. Check water supply valve at wall to fully
open.
4. If you have an external bidet filter, check
and replace if necessary.